C5CG13K1 - 607
REMOVAL - REFITTING REAR DOOR WINDOW
1 -
REMOVAL
Raise the glass the maximum amount
.
REMOVE THE TRIM PANEL
.
Detach the sealing film at the top, to access the window fixing (1), and at the bottom to access the lower fixing of the window mechanism
.
Release the fastener (1)
.
Lower the window using the control on the driver's door (if it does not lower, it must be lowered manually)
.
Unclip the fixed window pillar trim (2)
.
Remove
:
THE INTERIOR WIPE SEAL (3)
THE DOOR FRAME INTERIOR TRIM (4)
Using a spatula, remove the external weather strip (5) starting at the side (A)
.
Work the window groove seal (6) loose, starting at the top corner
.
Pull upwards and remove the front part of the seal
.
Remove the door pillar exterior trim mountings (7)
.
Detach the trim and let it hang down
.
Pull the window upwards to detach it from the door frame
.
Remove the glass
.
2 -
REFITTING
Unscrew the lower fixing of the window rail
.
Place the glass on the window without tightening the clamp
.
Fit the glass at the top and ensure that it is properly supported at the base of the slide seal; at the top
.
Tighten the clamp to the torque: 0,8 ± 0,2 danm
.
Lower the window fully
.
Tighten the lower fixing of the window rail
.
Check the operation
.
WARNING :
replace the exterior weather strip assembly if it was deformed on removal
.
IMPERATIVE :
IF THE SEALING SHEET IS TORN, REPLACE IT
.
Refit the finisher panel
.
Wyszukiwarka
Podobne podstrony:
C5CG13K2C5CG13K5C5CG13K1C5CG13K4C5CG13K7więcej podobnych podstron