A4 1998 diesel YES

background image

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.

aua498gbdt.doc

MAKE

AUDI

MOD.

A4*

YEAR

98

PETROL
DIESEL

* Models with original equipment keyless entry system

ALARM/SIREN
POSITION

Position the compact alarms and the sirens in the engine compartment, behind the
left lateral headlamp.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the dashboard, driver’s side,
on the left of the steering column.

POWER SUPPLY

+ 30: connect to the 4 mm

2

RED wire located in a 2 way connector in the fuse box.

- 31: connect to one of the wires coming out of the grounding shunt up on the left
lateral panel, driver’s side.

IGNITION WIRE

+ 15/54: connect with a terminal to the pivot marked 15A located on the relayholder
plate under the dashboard, driver’s side.

DIRECTION INDICATORS

Connect to the 1,5 mm

2

WHITE/BLACK and GREEN/BLACK wires located in the

wiring harness coming out of the 3 way black connector, behind the left covering,
driver’s side.

ALARM CONTROLS

Negative control signal
Connect to the RED/BLACK wire at the position nr. 11 of the 12 way black
connector for the setting off and to the RED/BLUE or RED/BROWN wire at the
position nr. 15 of the 16 way brown connector for the insertion. Both the connectors
are located directly on the coming out of the original compressor.

IMMOBILISATION POINT 1

Gasoil pump
Cut the 1,5 mm

2

BLUE/BLACK wire located in the wiring harness coming out of the

3 way connector directly on the gas oil pump in the engine compartment.

STARTER

+50: Cut the 2 mm

2

RED/BLACK wire located in the brown/violet connector on the

rear of the relay marked 205 under the dashboard, driver’s side.

BONNET SWITCH

Install an additional switch on the headlamp support plate, near the left headlamp.

DOORS SWITCH

To obtain the doors protection: (front door passenger’s side, rear doors driver’s
and passenger’s sides) connect the 0,5 mm

2

BROWN/WHITE wire located at the

position nr. 7 of the 15 way brown connector to the base of the pillar, driver’s side.
Connect to the BROWN/YELLOW wire located at the position nr. 8 of the above
mentioned connector to obtain the protection of the front door, driver’s side.

BOOT SWITCH

Connect to the BROWN/BLUE wire located at the position nr. 2 of the 16 way
brown connector coming out of the compressor.

X


Wyszukiwarka

Podobne podstrony:
A4 1998 diesel YES(1)
A4 2003 diesel YES(1)
A3 1998 diesel YES
A4 2003 diesel YES
A3 1998 diesel YES
A4 2001 petrol YES
A4 2003 diesel NO(1)
A4 2003 petrol YES(1)
A4 1996 diesel NO(1)
A3 2003 diesel YES(1)
156 2002 II sem diesel YES
A4 2001 petrol YES
A4 2003 petrol YES
A4 2003 diesel NO
A4 2001 petrol YES
audi a4 1998 stromlaufplan motor
audi a4 1998 stromlaufplan klima
audi a4 1998 stromlaufplan abs
A3 2003 diesel YES

więcej podobnych podstron