EXPLORER 1995-2001
EXPLORER 1995- 2001
WIRE
COLORS
LOCATION
12 VOLTS CONSTANT
YELLOW (X2)
IGNITION SWITCH HARNESS
IGNITION 1
RED/GREEN (+)
IGNITION SWITCH HARNESS
IGNITION 2
BLACK/GREEN (+)
IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER
BROWN (X2) (+) Must use Both
IGNITION SWITCH HARNESS
STARTER
RED/LIGHT BLUE (+)
IGNITION SWITCH HARNESS
PARKING LIGHTS (+)
BROWN or WHITE/BLACK
at HEAD LIGHT SWITCH or in DRIVERS KICK
PANEL
DOME LIGHT
See NOTE***
POWER DOOR LOCK
PINK/YELLOW
located in DRIVERS KICK PANEL (TYPE "C")
DRIVERS SWITCH is the MASTER
SWITCH See NOTE**
POWER DOOR UNLOCK
PINK/ GREEN
located in DRIVERS KICK PANEL (TYPE "C")
DRIVERS SWITCH is the MASTER
SWITCH See NOTE**
TACH SENSOR
TAN/YELLOW
at the PCM, located at the TOP of the FIREWALL,
passengers side. This wire can also be found at
the back of the Instrument cluster.
BRAKE
LIGHT GREEN (+)
at SWITCH on BRAKE PEDAL BRACKET
HORN
YELLOW/LIGHT GREEN (+)
in STEERING COLUMN HARNESS
FACTORY DISARM
DARK GREEN/PURPLE
in the DRIVERS KICK PANEL, harness coming
from the drivers door.
FACTORY ANTI-THEFT
TRANSPONDER (Ford's
SecuriLock) Most models 98 and
up.
Requires part #791 bypass module and extra
ignition key.
http://bulldogsecurity.com/New%20Wires/New%20Wires/Wires/forexplorer95-01.htm (1 of 2) [11/5/2004 10:06:31 AM]
EXPLORER 1995-2001
NOTE** If the vehicle IS EQUIPPED with FACTORY KEYLESS ENTRY the door locking system is a TYPE "B" use the same
color wires, but these wire will be of small gauge wire than the door lock motor wires of the same color. The KEYLESS ENTRY
Module is located in the LEFT REAR QUARTER PANEL. Without FACTORY KEYLESS ENTRY it is a TYPE "C"
system.
NOTE*** For the Dome Light Supervision or for an Alarms door pin trigger use these wires. For the DRIVERS DOOR use the
YELLOW/BLACK (-) in the drivers door harness, for the DRIVERS REAR DOOR use the LIGHT GREEN/YELLOW (-) located in the
drivers kick panel. In the PASSENGERS KICK PANEL use the GRAY/RED (-) for the PASSENGERS DOOR and for the
PASSENGERS REAR DOOR use the PINK/LIGHT BLUE (-) all of these wires are (-) Negative triggers and MUST BE DIODE
ISOLATED when connecting to an alarm system. For DOME LIGHT SUPERVISION just use the DRIVERS DOOR YELLOW/BLACK
(-).
http://bulldogsecurity.com/New%20Wires/New%20Wires/Wires/forexplorer95-01.htm (2 of 2) [11/5/2004 10:06:31 AM]