{\rtf1\ansi\deff0{\fonttbl{\f0\fnil MS Sans Serif;}} {\colortbl ;\red255\green0\blue0;\red0\green0\blue0;} \viewkind4\uc1\pard\qc\cf1\lang2057\b\f0\fs24 G98 (Per Minute Feed) \par \cf2\b0\fs20 \par \pard\cf1\b\fs24 \par \cf2\b0\fs20 The G98 command allows a feedrate written in the units, millimetres per minute or inches per minute, to be entered into the machine controller. All subsequent feedrates are defined in the chosen units, after the original read-in of the command G98. If a change of feedrate is required within a program, only the F __ value needs to be entered. \par The units used will depend on whether the machine is operating using metric or imperial measurements. \par \par \par A G98 feedrate command is written in the following format: \par G98 F __ ; \par where, \par F __ is the feedrate, written in the format millimetres per minute or inches per minute. \par \par \par \cf1\b\fs24 \par \par \par \par \par \par }