SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL X
BMW SERIE 5* 01 DIESEL

MAKE MOD. YEAR.
* Models with original equipment keyless entry system.
ALARM/SIREN Position the compact alarms and the sirens in the engine compartment, on the bulkhead
of the left lateral mudguard. Pass the cables through the original hole located on the
POSITION
bulkhead that divides the engine compartment and the passenger s compartment
corresponding to the passenger s side shock absorber.
CENTRAL UNIT POSITION The modular systems and the modules should be positioned under the dashboard,
driver s side.
POWER SUPPLY + 30: connect to the 5 mm2 RED wire located in a multiway connector at the entrance of
the fuse box.
- 31: Connect with a cable terminal to one of the original ground terminals located on
the left lateral bulkhead , driver s side.
IGNITION WIRE + 15/54: Connect to the 1 mm2 GREEN/GREY wire located in the wiring harness
behind the right lateral bulkhead, passenger s side.
DIRECTION INDICATORS Connect to the 1,5 mm2 BLUE/GREEN and BLUE/BROWN wires located in the same
wiring harness mentioned above.
ELECTRIC WINDOWS Comfort closing
Positive control signal
Connect to the BLUE/RED wire, the same used for the activation of art. 38XX.
ACTIVAT./DEACTIVATION Connections antitheft/vehicle
CONTROLS Art.38XX Vehicle Position
GREY/BLACK BLUE black connector
YELLOW/BLACK BLACK black connector
VIOLET/WHITE ground car body
ORANGE BLUE/RED wiring harness inside driver s side door
VIOLET WHITE/BLACK wiring harness inside driver s side door
ORANGE/WHITE ground car body
The BLUE and BLACK wires are located in the black connector coming out of the central
locking unit placed behind the glove compartment, passenger s side.
Refer to the diagram nr. 148.
IMMOBILISATION POINT Fuel pump
Cut the 1,5 mm2 GREEN/BLACK wire located in the wiring harness coming out of the
fuse marked F14, in the fuse box, placed under the dashboard, passenger s side.
STARTER +50: Cut the 3 mm2 BLACK/YELLOW wire located in the wiring harness coming out of
the connector of the ignition key.
BONNET SWITCH Install an additional switch on the front headlamp support grill, driver s side.
DOORS SWITCH Connect to the BROWN/RED, BROWN/WHITE, BROWN/GREY and BROWN/WHITE
wires located in the wiring harness coming out of the connector of the central locking
unit.
BOOT SWITCH Connect to the 1 mm2 WHITE/BROWN wire located directly in the wiring harness
coming out of the connector of the boot lamp.
bmse501gbbt.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
FITTING DIAGRAM N° 148
Diagram to connect art. 3800 on
BMW 5 serie
Central locking unit
Art. 3800 black connector
Wiring harness inside
driver s side door
BLUE BLACK
WHITE/ BLUE/
BLACK RED
YELLOW/BLACK
ORANGE/WHITE
VIOLET/WHITE GREY/BLACK
ORANGE
Diodes 1N4004
VIOLET
open close
M
+30
bmse501gbbt.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.