SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

X

MAKE

SEAT

MOD.

TOLEDO

YEAR

00 �ął PETROL

DIESEL

ALARM/SIREN

Position the compact alarms and the sirens in the engine compartment, on the POSITION

bulkhead that divides the engine compartment from the passenger’s compartment. Pass the cables through the original rubber sleeve located under the brake fluid reservoir.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the driver’s side dashboard or as alternative behind the driver’s side panel.

POWER SUPPLY

+ 30: connect with a ring terminal to the pin marked �ś+30” located on the feed rod in the lower part of the fuse box.

- 31: connect with a ring terminal to the weight shunting located above, on the left of the fuse box.

IGNITION WIRE

+ 15/54: connect to the 2 mm2 BLACK wire in the central part of the fuse box located on the left lateral bulkhead, driver’s side.

DIRECTION INDICATORS

Connect to the 1 mm2 BLACK/WHITE and BLACK/GREEN wires located in the wiring harness coming out of the lights switch connector.

ELECTRIC WINDOWS

Comfort closing

Negative control signal The total closing of the windows is obtained timing the lock control (Violet) of the car alarm to 24s.

CENTRAL DOORS LOCKING

Negative control signal Connect to the 0,75 mm2 YELLOW/BLUE wire (lock) and GREN/RED wire (unlock) located in the wiring harness that goes from the push-button panel to the switch directly inside the driver’s side door.

IMMOBILISATION POINT 1

Fuel pump

Cut the 1 mm2 BLUE/YELLOW in the wiring harness coming out of the 6 way light brown connector located on the connectors holder, under the driver’s side dashboard.

IMMOBILISATION POINT 2

Positive relè pump

Cut the 1 mm2 RED/VIOLET wire located on the coming out of the fuse marked nr. 32, in the fuse box, above the left lateral panel, driver’s side.

BONNET SWITCH

Install an additional switch on the headlamp support plate, above on the left of the driver’s side lamp.

DOORS SWITCH

Connect to the 1 mm2 GREY/BLUE wire located at the position nr. 16 of the connector coming out of the central doors locking unit under the driver’s side dashboard.

BOOT SWITCH

Connect to the 1 mm2 BROWN/BLACK wire located in the wiring harness of the driver’s side sill cover.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed setol00gbb.doc

as per the instructions given on the product installation manual.