CCNA 2 RSE Final Exam Answers 2013

1

Refer to the exhibit. What can be concluded about network 192.168.1.0 in the R2 routing table?

This network was learned through summary LSAs from an ABR.
This network should be used to forward traffic toward external networks.
This network is directly connected to the interface GigabitEthernet0/0.
This network has been learned from an internal router within the same area.
__________________________________________________________________

2
Which address is used by an IPv6 EIGRP router as the source for hello messages?

the interface IPv6 link-local address
the all-EIGRP-routers multicast address
the IPv6 global unicast address that is configured on the interface
the 32-bit router ID
__________________________________________________________________

3
What are two differences between the Cisco IOS 12 and IOS 15 versions? (Choose two.)

The IOS 12 version has commands that are not available in the 15 version.
The IOS version 15 license key is unique to each device, whereas the IOS version 12 license key is not device specific.
Every Cisco ISR G2 platform router includes a universal image in the IOS 12 versions, but not the IOS 15 versions.
IOS version 12.4(20)T1 is a mainline release, whereas IOS version 15.1(1)T1 is a new feature release.
The IOS 12 version has two trains that occur simultaneously, whereas the IOS 15 version still has two trains, but the versions occur in a single sequential order.
__________________________________________________________________

4
Which ACE will permit a packet that originates from any network and is destined for a web server at 192.168.1.1?

access-list 101 permit tcp host 192.168.1.1 eq 80 any
access-list 101 permit tcp host 192.168.1.1 any eq 80
access-list 101 permit tcp any host 192.168.1.1 eq 80
access-list 101 permit tcp any eq 80 host 192.168.1.1
6
What are two features of a link-state routing protocol? (Choose two.)

Routers create a topology of the network by using information from other routers.
Routers send triggered updates in response to a change.
The database information for each router is obtained from the same source.
Routers send periodic updates only to neighboring routers.
Paths are chosen based on the lowest number of hops to the designated router.
__________________________________________________________________

13
A network administrator issues the command R1(config)# license boot module c1900 technology-package securityk9 on a router. What is the effect of this command?

The features in the Security package are available immediately.
The Evaluation Right-To-Use license for the Security technology package is activated.
The IOS will prompt the user to reboot the router.
The IOS will prompt the user to provide a UDI in order to activate the license.
__________________________________________________________________

20

Refer to the exhibit. Which of the three Cisco IOS images shown will load into RAM?

The router selects an image depending on the value of the configuration register.
The router selects an image depending on the boot system command in the configuration.
The router selects the third Cisco IOS image because it contains the advipservicesk9 image.
The router selects the third Cisco IOS image because it is the most recent IOS image.
The router selects the second Cisco IOS image because it is the smallest IOS image.
__________________________________________________________________

24
Which packet types are implicitly permitted by IPv6 ACLs?

ping packets
IPv6 unicast packets
router solicitation packets
neighbor discovery packets

__________________________________________________________________

27
A router is participating in an OPSFv2 domain. What will always happen if the dead interval expires before the router receives a hello packet from an adjacent DROTHER OPSF router?

OSPF will run a new DR/BDR election.
A new dead interval timer of 4 times the hello interval will start.
OSPF will remove that neighbor from the router link-state database.
SPF will run and determine which neighbor router is “down”.
__________________________________________________________________

32
Which three requirements are necessary for two OSPFv2 routers to form an adjacency? (Choose three.)

The two routers must include the inter-router link network in an OSPFv2 network command.
The OSPF hello or dead timers on each router must match.
The OSPFv2 process ID must be the same on each router.
The link interface on each router must be configured with a link-local address.
The OSPFv2 process is enabled on the interface by entering the ospf process area-id command.
The link interface subnet masks must match.
__________________________________________________________________

33

Refer to the exhibit. What two types of devices are connected to R1? (Choose two.)

Hub
Repeater
Switch
Source Route Bridge
Router

__________________________________________________________________

44

Refer to the exhibit. The R1 router is participating in a multiarea OSPF network. What can the network administrator determine from the output?

The router does not have a default gateway.
The routing protocol configuration mode network commands have been entered on this router and adjacent routers.
The correct wildcard masks have not been entered properly as part of the network commands entered on this router.
The router has been configured to not participate in DR/BDR elections on interfaces Serial 0/0/0 and Serial 0/01.
__________________________________________________________________

47
Which two commands will configure OSPFv2 MD5 authentication on a router interface? (Choose two.)

router ospf 10
default-information originate
ip ospf message-digest-key 1 md5 CISCO-ABC
ip ospf priority 255
ip ospf authentication message-digest
area 0 authentication message-digest
__________________________________________________________________

48
What happens immediately after two OSPF routers have exchanged hello packets and have formed a neighbor adjacency?

They negotiate the election process if they are on a multiaccess network.
They exchange abbreviated lists of their LSDBs.
They exchange DBD packets in order to advertise parameters such as hello and dead intervals.
They request more information about their databases.
__________________________________________________________________

49
The following network assignments have been made in a company:
10.50.0.0/28
10.50.0.128/26
10.50.0.40/29

A company branch office has recently added an IP-based video surveillance system that requires a server and 20 cameras to be on a separate network. Which network number and mask could be used for this network if the branch office is using an overall block of addresses of 10.50.0.0/24?

10.50.0.32/28
10.50.0.48/27
10.50.0.96/28
10.50.0.32/27
10.50.0.64/27
__________________________________________________________________

51
What are three characteristics of the Cisco IOS Software Release 12.4T train? (Choose three.)

It has extended maintenance new feature releases approximately every 16 to 20 months.
It is updated with new features and hardware support.
It has a number of embedded technology packages.
It receives regular software fixes that are synchronized with the 12.4 Mainline train.
It is derived from the Cisco IOS Software Release 12.4 Mainline train.
It requires the activation of a license.
__________________________________________________________________

58

Refer to the exhibit. What are two things that are different about the highlighted E2 routes in the routing table? (Choose two.)

These routes were learned using Type 5 LSAs.
These routes are networks contained to other routers in a different OSPF area.
These routes can be used as backup default routes.
These routes are used to reach networks outside the OSPF multiarea network.
These routes have an administrative distance of 20.
These routes are networks connected to other routers in the same OSPF area.
__________________________________________________________________