298

I

MANUAŁ STEERING GEAR AND LINKAGE — R22T

_Assembly and Adjustment (Cont'd)_

Oil seal side

6. Install retainer, retainer spring, adjusting screw and lock nut.

Retainer k-z ,-Retainer spring

Adjusting screw n Adjusting screw lock nut

8)

4)

5)

6) 7)

5. Install snap ring, snap ring cap and oil seai.

Pay attention to the direction of the snap ring cap.

SST554A

SST555A

7. Adjust pinion rotating torque as follows.

1)    Set gears to Neutral position.

2)    Loosen lock nut.

3)    Tighten adjusting screw one or two times to a torque of 4.9 N-m (50 kg-cm, 43 in-lb).

Rotate pinion to move rack back and forth two times, and return it to Neutral position.

Loosen adjusting screw and retighten it to a torque of 5.4 N-m (55 kg-cm, 48 in-lb).

Back the adjusting screw off 40° to 50°.

Prevent adjusting screw from rotating and tighten lock nut to specified torque holding adjusting screw in place.

SST557A

While slowly rotating pinion, make surę that’ its rotating torque is within the specifications.

Average value:

1.0 - 1.4 N-m

(10 - 14 kg-cm, 8.7 - 12.2 in-lb)

Maximum allowable value:

1.5 N-m (15 kg-cm, 13 in-lb)

Minimum allowable value:

0.3 N-m (3 kg-cm, 2.6 in-lb)

Minimum value -

Average value ■ {Max. value * Min. vaiue) x 0.5

Pinion I rotating ¹ torgue