plik


ÿþSPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00 www.cobra.it PETROL X AUDI A3 98 ’! DIESEL ’! MAKE MOD. YEAR. ALARM/SIREN Position the compact alarms and the sirens in the engine compartment, on the ABS bracket. Pass the cables through the rubber sleeve located on the panel that POSITION divides the engine compartment and the passenger s compartment near the shock absorber, driver s side. CENTRAL UNIT POSITION Position the modular systems and the modules on the left-hand side under the dashboard on the driver s side. POWER SUPPLY + 30: connect to the 4 mm2 RED wire located in the general supply wiring of the fuse box. - 31: connect with a ring terminal to one of the terminals coming out of the general power supply behind the lateral panel on the driver s side. IGNITION WIRE + 15/54: connect to the 2 mm2 BLACK wire located in the multiway connector in the central part of the fuse box on the left of the dashboard. DIRECTION INDICATORS Connect to the 1,5 mm2 BLACK/WHITE and BLACK/GREEN wire located in the wiring harness under the sill cover on the left side of the driver s side. CENTRAL DOORS LOCKING Negative control signal AND ELECTRIC WINDOWS Connect to the GREY lock and RED/BROWN unlock wires at positions nr. 1 and nr. 3 located in the light brown connector behind the left panel, driver s side. CLOSING Total closure To close the windows completely, you must set lock command wire to 24s. IMMOBILISATION POINT 1 Fuel pump Cut the 1,5 mm2 BLUE/RED wire located in the wiring harness under the left sill cover, driver s side. IMMOBILISATION POINT 2 Ignition key Cut the 1,5 mm2 BLACK/VIOLET wire located in the wiring harness coming out of the multiway connector in the fuse box. STARTER +50: Cut the 1,5 mm2 BLACK/RED wire located in the wiring harness coming out of the connector of the ignition switch. BONNET SWITCH Install an additional switch on the headlamp support plate, near the original bonnet bumper rubber. DOORS SWITCH Connect to the BROWN/WHITE wire located in the wiring harness under the sill cover, on the left side, going to the rear. BOOT SWITCH Connect to the 1 mm2 WHITE/BLACK wire at position nr.4 of the 6 way black connector on the left side of the boot. aua398gbb.doc Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed as per the instructions given on the product installation manual.

Wyszukiwarka

Podobne podstrony:
166 T S 1998 petrol NO
A6 1998 petrol NO
SERIE 3 1998 petrol NO
GT 2004 petrol NO
PT CRUISER 2001 petrol NO
A4 2001 petrol NO
X 5 2001 petrol NO
A2 2004 2°sem 1 petrol NO
145 1997 petrol NO
530 2003 petrol NO
GTV 1999 petrol NO

więcej podobnych podstron