floral bag en

background image

copyright

©

STUDIO TUUMAT OY PL 46 90401 OULU FINLAND INFO: ottobre@ottobre.fi

FLORAL BAG

Side height 20 cm
Base 17 cm x 23 cm

MATERIALS
- 50 cm cotton twill or similar fabric
- 25 cm fusible wadding (Vlieseline® H 630 or H 640)
- 20 cm fusible fleece
- 20 cm x 58 cm piece of volume fleece
(Vlieseline® Volumenvlies 272)
- 20 cm x 25 cm piece of cardboard for base
For flower motifs:
- piece of blue cotton twill
- double-sided fusible web, Vlieseline®Vliesofix
- embroidery stabilizer, Vlieseline® Soluweb
- embroidery thread

PATTERN PIECES

cut

exterior

lining

1 side panel (=1a+1b)

2

2

2 base panel

1

1

3 handle (=3a+3b+3c)

2

 flower motifs

1+1

CUTTING
Cut side panels, base panel and handles from cotton twill. Add
1 cm seam allowances to edges. Note! Cut lining panels slightly
smaller than exterior panels.

Cut also:
- side panel twice from fusible wadding without adding
seam allowances
- base once from both fusible fleece and cardboard without
adding seam allowances
- two 20 cm x 29 cm pieces from volume fleece for handles
- two 10 cm x 10 cm pieces and two 13 cm x 13 cm pieces
from blue cotton twill for flower motifs

INSTRUCTIONS
Preparation:
Iron fusible wadding onto exterior side panels
and fusible fleece onto exterior base panel.
Handles: Fold handle piece in half lengthwise, right sides
together, and stitch its edges together between notches in the
mid-part of the piece. Trim seam allowances and turn handle
right side out. Roll up piece of volume fleece lengthwise and
stitch its tail end to roll by hand. Insert volume fleece roll into
mid-part of handle. Construct the other handle in the same
way. Fold and press seam allowances on open edges of handles
to inside. Pin handles to exterior side panels as marked on
pattern and stitch them in place close to edges.
Joining: Pin exterior side panels together, right sides facing,
and stitch side seams. Stitch side seams of lining in the same
way. Press seams open and topstitch on both sides of seam
using presser foot edge as guide.

Pin bag exterior and lining together, right sides facing, and stitch
top edges together. Turn bag side sections right side out but
do not insert lining into bag exterior. Understitch top-edge
seam allowances to lining.
Insert lining into bag exterior and machine-baste their bottom
edges together.

Turn bag side section so that lining is on the outside. Pin and
stitch exterior base panel to bottom edge of bag, with right
side of base panel facing right side of exterior side section.

With your hand, press bag side section carefully flat against
exterior base panel and fasten it in the middle of base with
safety pins. Pin base lining panel on top (right side of base lining
facing right side of exterior base panel) and stitch edges of
base panels together, leaving opening (B-B) for turning bag right
side out. Trim seam allowances and turn bag right side out.
Insert cardboard between base panels. Close opening in base
seam by hand-stitching.
Flower motifs: Fuse two pieces of blue twill together, wrong
sides facing, using double-sided fusible web. Trace flower motifs
from pattern sheet on embroidery stabilizer, pin stabilizer to
piece of twill and embroider motifs with reinforced straight
stitch. Remove embroidery stabilizer. Cut flowers out with
5 mm seam allowances and fray their edges. Attach flowers
to bag with a few hand stitches.

B

B

2

1a

1b

3a

3b

3c

background image

copyright

©

STUDIO TUUMAT OY

PL 46 90401 OULU FINLAND INFO: info@ottobre.fi

TARKISTUSRUUTU

CONTROL SQUARE

KONTROLLRUTA

CONTROLEVELD

KONTROLLFELD

5 cm x 5 cm

CONTROL

SQUARE

2 x 2 inches





1b

3a

3c

B

B

2





1a

3b


Wyszukiwarka

Podobne podstrony:
denim bag en torebka opis wykonania szablony
furry bag en torebka = opis wykonania szalon(1)
furry bag en torebka = opis wykonania, szalon
bag bamboo handles en torebka
Budzik Versa wielkość karty kredytowej instrukcja EN
G2 4 PW EN wn Rys 01
Manual Acer TravelMate 2430 US EN
Ćwiczenie 01 EN DI
eci en
BVSOI 3 001 E en
A Biegus projektowanie konctrukcji stalowych wg PN EN 1993 1 1 cz 1
Flavon Active dopping EN
5817 PN EN ISO IV 2007
Pisownia ę ą en em om
NS2 lab 4 4 7 en Configure Cisco IOS IPSec using Pre Shared Keys

więcej podobnych podstron