Connect the adapter to the car and the computer.
Choose the type of adapter (if using Carsoft 7.4). On cars equipped with 38 pin diagnostic connector to use a cable of the 3 wires (do not use a standard plug 38 pin). Connection (38 pin):
1 - ground (black)
3 - supply voltage (red)
4 - k-line (yellow)

Increase the speed to 3000 and keep them within 30-60 seconds.
Turn the ignition on and press [Connect].
Wait until you turn off the led "Wait. "
Next you will see "Waiting for start-up" and then start the motor.
Warm up the engine to operating temperature(>85*).
Let it idle for at least 5 minutes.
Increase the speed to 2000 and keep them within 30-60 seconds.
Increase the speed to 2500 and keep them within 30-60 seconds.
Increase the speed to 3000 and keep them within 30-60 seconds.
Go to idle.
In the presence of automatic transmission include "drive" and wait about a minute, turn off the "drive".
If you wish to check flow to the cutoff: gently press the gas and watch that rpm is not exceeded 4500, the engine should start to work in the 4000 revolutions (up-down) and then press the gas to the floor and wait 3 seconds.
Run the engine at idle a few minutes.
Turn off the ignition.
Pack the Logs folder and send at [e-mail]