{\rtf1\ansi\ansicpg1252\deff0\deflang2057{\fonttbl{\f0\fnil MS Sans Serif;}{\f1\fnil\fcharset0 Verdana;}}
{\colortbl ;\red255\green0\blue0;}
\viewkind4\uc1\pard\qc\cf1\b\f0\fs24 G94 End_Taper Face Turning Cycle
\par \pard
\par \cf0\b0\f1\fs16
\par The G94 command performs a one pass face cutting cycle, where the cut is applied in the Z axis.
\par Also, by using the word R __ within a G94 command, tapers can be generated.
\par If a repartition of the move is required, only the values that change need to be entered into the next block.
\par
\par A G94 command for a face cutting cycle is written in the following format:
\par G94 X (U) __ Z (W) __ F __ ;
\par where,
\par F __ is the feedrate
\par
\par A G94 command for a taper face cutting cycle is written in the following format:
\par G94 X (U) __ Z (W) __ R __ F __ ;
\par where,
\par F __ is the feedrate.
\par R __ is the size and angle of the taper.
\par
\par \f0
\par }