{\rtf1\ansi\ansicpg1252\deff0{\fonttbl{\f0\fnil\fcharset0 MS Sans Serif;}{\f1\fnil MS Sans Serif;}{\f2\fnil\fcharset0 Verdana;}}
{\colortbl ;\red255\green0\blue0;\red0\green0\blue0;}
\viewkind4\uc1\pard\qc\cf1\lang2057\b\f0\fs24 CYCLE DEF 2_0\f1 \f0 Tapping\f1
\par \pard
\par \cf2\b0\fs20 Peck drilling cycles should be used where the hole depth is more than 2 x the hole diameter.
\par
\par
\par \cf0\f2\fs16 CYCLE DEF 2.0 TAPPING \cf2\f1\fs20\tab\f0 Tapping cycle\f1
\par \cf0\f2\fs16 CYCLE DEF 2.1 SETUP \cf2\f1\fs20\tab Set-up clearance
\par \cf0\f2\fs16 CYCLE DEF 2.2 DEPTH\cf2\f1\fs20\tab Total hole depth (\f0 length of thread\f1 )
\par \cf0\f2\fs16 CYCLE DEF 2.3 PECKG\cf2\f1\fs20\tab Pecking depth (depth of cut)
\par \cf0\f2\fs16 CYCLE DEF 2.4 DWELL\cf2\f1\fs20\tab Dwell
\par \cf0\f2\fs16 CYCLE DEF 2.5 \cf2\f1\fs20\tab Feed rate
\par
\par Parameter\f0 'SET UP'\f1 must have the same value as the distance in Z from the tool to the work piece surface when the tool is in starting position i.e. -1.
\par
\par Cycle parameters \f0 'SET UP,DEPTH,PECKING DEPTH'\f1 must have the same sign - usually - (minus).\cf1\b\fs24
\par
\par
\par
\par
\par }