Audi A6 (974)5) 1,8 Turbo 19974)2 Engine codę: AEB
Impoitant notę
Replacement lnteival Guide
Check For Engine Damage
Repaii Times - his
Special Tools
Special Precautions
Removal instaiiation
1. Ensure timing mark aligned (5).
2. Fit timing belt to crankshaft sprocket and auxiliary shaft sprocket.
NOTĘ: If reusing old belt: Observe direction of rotation maiks on belt.
3. Install:
o Timing belt lower cover (9). o Crankshaft pulley [8]. o Crankshaft pulley bolts (7).
4. Lightly tighten crankshaft pulley bolts (7).
5. Ensure timing mark on crankshaft pulley aligned [6].
6. Fit timing belt to tensioner pulley and camshaft sprocket.
7. Slacken tensioner bolt (10).
8. Fit two-pin wrench (13). Tool No.Matra V.159.
NOTĘ: Two-pin wiench locates in hole [1G] and against Ing [17J. Wlien tuining two-pin wrench clockwise. the tensioner pulley will turn a nti-clockwise and apply tension to belt.
9. Tum two-pin wrench clockwise (15) until piston (14) (A) is fully extended and piston (14) (B) has risen approximately 1 mm.
10. Lightly tighten tensioner bolt (10).
11. Turn crankshaft two turns clockwise.
12. Ensure timing marks aligned (5) & (6).
13. Check alignment of tensioner lever (14) (C) in relation to upper edge of piston (14) (B) as follows:
o (14) (D) - adjustment correct, o (14) (E) - wear area, re-adjust. o (14) (F) - check tensioner and re-adjust.
14. When adjustment correct, dimension (14) (G) will be 25-29 mm.
15. If alignment incorrect or dimension (14) [G] not as specified: Repeat tensioning procedurę.
NOTĘ: Aftei instaiiation, correct adjustment is maintained providing upper edge of piston [14] [B] is positioned within areas [14] [D] and [14] [EJ.
16. Tighten tensioner bolt to 25 Nm (10).
17. Tighten crankshaft pulley bolts (7). Tightening torque:
o Class 8.8 = 10 Nm + 90° Use new bolts. o Class 10.9 = 40 Nm.
(A4 - 45 Nm) (A5 - 50 Nm)