14 1

14 1



1.    Until SW1 is CLOSED the Circuit uses no current.

About 90 seconds after SW1 is closecl the Buzzer will sound. The exact delay depends on the actual components used.

You can adjust the delay by altering the values of R1 and/or Cl. Any of the three Cmos ICs may be used.

2.    Until SW1 is CLOSED the Circuit uses no current.

About 90 seconds after SW1 is closed the Buzzer will begin a series of short Beeps, 3 to 5 seconds apart. This saves battery power. R5 & C2 set the length of the beeps; R4 & C2 the delay between them. A Cmos 4001 IC is NOT suitable for this Circuit.


Wyszukiwarka

Podobne podstrony:
14 2 3. While Swl remains CLOSED the Circuit uses virtually no current. About 90 seconds after SW1 i
14 3 5. While Swl remains CLOSED the Circuit uses virtually no current. When the switch is OPENED th
1 (159) Strona 20 z 46 Spy Circuits8. CLASS "C" OUTPUT The following Circuit uses no biasi
14 4 7. While Sw 1 remains OPEN the Circuit uses virtually no current. Every time Swl is CLOSED the
14 5 9. In standby modę this Circuit uses virtually no current. When Swl is EITHER opened or closed,
14 HEADGAMES CONTEMPORARY FASHION PANORAMA The human as a whole is the center around which Javier Ma
27. A gas well with 40 ppm H2S and 14 mole-% CO2 is planned to be produced up a string of tubing cem
Cueing is accurate. damped in both di-rections. and operable with ihe dusi cover closed. The tumtabl
14 6 11. Every 4 to 5 minutes the Circuit measures the temperaturę. If it s BELOWthe level set by R7

więcej podobnych podstron