MR293R19076 1
Refitting
Jold the hood forward.
Bond t^e rear screen tensioner section in place.
Refit the rubber seal.
Fully close the hood and bond the sidc sections in place. Ensure that there are no creases m rt.
Reposition the sinall side tensioner straps.
Start at the rear.
Clip the rear section im place, t.aking care ta ensur* t-hat it. i s oxactly central (thoro is a mark on it).
Pass through the tenaioner cable and secure it in place.
Tilt thn hood forwards and bond the front, snction in place.
Piorce hole3 in the cover and refit the plastic elips.
Resecure the front angin section and corner sections.
Wyszukiwarka
Podobne podstrony:
MR293R19019 1 COMNECTIOH WITH THE REAR LIGHT SUPPORT PANEL Cutting/UnpLcking CONNECTION WITH THE RE
MR293R19095 1 Fit the tikirt in place on the front and rear elips. Mark and tram t.hr location of t
MR293R190)5 1 REHOVAL 2HD TTPE Using a suction pad, remove the gla3S {dęlicate operation). REFITTING
MR293R19007 1 2 CONKECTION WITH THE BODY SIT.J. Thickness of metal Cin mm) ŚtŁffsner Body sili C ut
MR293R19014 1 CONNECTION WITH THE BODY SILL AND CENTRE DOOJR PILLAR Thicknesa of metal (in mm) Wi n
MR293R19080 1 Carnfully rewove the rivets from thp tensioner straps, on the sfcretchers. Remove the
MR293R190 4 1 RENOYAŁ Adjustlng the striker piąte. Remove the two screws (1) and puli the lock, turn
MR293R190(4 1 REHOTAL See the 3ection entitled "GENERAL-Tooling and Products". Puli on par
21775 MR293R19073 1 After lowering the hooćL Removing Remove the piastic elips, free the two corres
więcej podobnych podstron