39944 Page

Before you begin to put the model together get skewers or plastic sticks (for example from frames of plastic aeroplane models) for various compiements or tor tuDe-wrapping. you will also need glue, scissors, ruler, a Sharp knife and cardboard 1 -2mm thick to pastę the parts 4, 6, 7, 9,12,19, 21,27 and 31 on. The basie part of the boat is the hull 1 connected inside with the links 1 a to 1 f, closed by the Stern and the duet 3. Stick the cockpit 5 and timber 6 to the deck 4 from the inside and carefully cover the hull. Fili the cockpit with benches from parts 7 to 10. Attention: glue the parts only tothree sides, the front side must remain free - part 11 willfit in. Parts 12 to 19 will be stuckon it. Glue the hinges 17 and 18onto the benches 7 and 9, and stick part 19 from the inside to the middle front side of part 11. This part is intrornited into deck 4 and serves for an easy decomposition of the hull and superstructure. Put the machine-gun tower together from parts 20 to 29 according to drawing. You can add the lifebuoy from parts 30 to 32. According to the drawing, put together also the swivel-gun from parts 33 to 46 and glue it into the cockpit, Add the roof from parts 47,48 and 49 which is installed upon 5 sticks of 1 mm in diameter, 35 mm long, anchored in theaperturesindeck4. Put together the shaftsuspender 50,51,51 a, 52; wrap parts 51 and51aaroundtheshaftof 2mm in diameter and 70 mm length. Put on it also the hub of the propeller 53 complemented by the vanes 54 and nut 55. Install a swivel rudder madę of parts 55 to 58 and shaft of 1 to 1,5mm in diameter and 30 mm in length. At the end it only takes adding various compiements 59 to 61, flag tubes 62, headlights from parts 63 to 68, ropę grips 69 and exhaust 70. The boat has a removable superstructure and it is possible to install an electric engine with batteries in it to drive the screw propeller (best in diameter up to 20 mm). In this case it is necessary to cover the model with several layers of varnish, also the internal parts.