■ • it!vncr *- esc" it> ?'■-Remove bearing inner race on shim side only and take out shim.
10. Install bearing retainer to transmission case.
11. Attach converter housing and gasket to transmission case. Tighten bolts to the same torque in a crisscross fashion.
12. Measure diff. side bearing preload with KV38105900.
(J33201)
SAT665
Specified diff. side bearing preload:
2.9 - 4.4 N-m (30 - 45 kg-cm, 26 - 39 in-lb)
a. Tum finał drive assembly at least 10 times before measuring diff. side bearing preload.
b. Changes in diff. side bearing preload per revolution shouid be within 1.0 N-m (10 kg-cm, 8.7 in-lb) without binding.
c. If any abnormalities are noted in b. above, or diff. side bearing preload is outside specified rangę, disassemble and reassemble again.
13. Disassemble transmission case and remove finał drive assembly.
3.
4.
5.
SAT455
Press fit bearing inner race into place without shim.
Press
Install finał drive assembly on transmission case.
Place gasket on transmission case, then install converter housing. ;;Ł,q
Tighten bolts to the same torque in a crisscross fashion.
Attach dial gauge using Tool KV38106000.
If clamp diameter of dial gauge is too smali or too large, attach dial gauge to Tool KV38106000 using a magnetic stand.