Temporarily tighten 26 - 36 N-m
(2.7 - 3.7 kg-rn, 20 - 27 ft-lb)
22. If transmission case, output shaft, tapered roller bearing or front cover is replaced, output shaft should be adjusted by means of shims.
1) Lubricate bearing outer race.
2) Press bearing outer race into converter housing.
3) Install two or three shims on front cover, and press bearing outer race into front cover.
4) Install gasket and front cover on converter housing.
5) Measure output shaft preioad.
Specified output shaft bearing preioad:
0.15 - 0.32 N-m
(1.5 - 3.3 kg-cm, 1.3 - 2.9 in-lb)
a. Turn output shaft at least 10 times before measuring output shaft bearing preioad.
b. Ensure that output shaft turns smoothly with-out binding.
c. If any abnormalities are noted in b. above, or output shaft bearing preioad is outside specified rangę, disassemble and reassemble again.
ST3127S000 (See J25765-A)
SAT352
Available shims: Refer to S.D.S.
23. Adjust idler bearing preioad as follows.
1) Clean threads of bolts and converter housing with solvent.
2) Apply locking sealer to threads of bolts and install them into place.
3) Install lock washer and idler gear bolt, and tighten bolt to specified torque.
Be surę to align lock washer with groove on conver-
tor housing.
4) After tightening bolt, turn output shaft five complete rotations. Loosen idler gear bolt, then tighten it to specified torque.
5) Bend lock washer.
SAT354
6) Turn output shaft to make surę it operates smoothly.