255
FRONT AXLE — Wheel Hub and Knuckle
-Inspection_
WHEEL BEARING
Make surę wheel bearing roiIs freely and is free from noise, crack, pitting or wear.
-Assembiy and Adjustment_
1. Coat each bearing with recommended multi purpose grease.
Refer to section Gl.
WHEEL HUB AND KNUCKLE
Check wheel hub for cracks by using of a magnetic exploration or dyeing test, and replace if cracked.
GREASE SEAL
If grease leakage is detected during removal, re-piace grease seal. Replace grease seal at every disassembly, even if it appears good.
FA262
2. Press bearing outer race into each side of knuckle.
Wyszukiwarka
Podobne podstrony:
FRONT AXLE — Wheel Hub and Knuckle Wheel nut [□] 98 - 118 (10.0-12.0,72-87) - Hub cap inner and oute
FRONT AXLE — Wheel Hub-and Knuckle k rt tAssembly and Ad 4. Press outside grease seal and bearing. 0
FRONT AXLE — Wheel Hub and Knuckle— Assembly and Adjustment (Cont d)..Installation.8. Measure bearin
89 TransAlp Manual Front Wheel Suspention Steering 6 FRONT WHEEL/SUSPENSION/STEERINGINSPECTION• AXL
t=RONT AXLE — iWheel >Hub iandJKnućkle.Remoual (Cont d)__Disassembly. WHEEL HUB • Remove drive
FRONT AXLE — Drive Shaft InspectionDisassembly (Cont d) • Remove snap ring, and withdraw inner race.
CHASSIS AND BODY MAINTENANCEChecking Front Axle and Front Suspension Parts • Check axle and suspensi
23166 Suzuki RM125? CLUTCH 7-7PRIMARY DRIVEN GEAR ASS Y INSPEC-TION ♦ Inspect the clutch sleeve hub
FRONT AXLE & FRONT SUSPENSION SECTION CONTENTS FRONT AXLE AND FRONT
page3637 . . 36 FRONT AXLE I. Tolerances and Wear Limiłs T"i="jir sss jflfsf*
22451 Suzuki RM2504 15-8 FRONT FORK AND STEERING • Make surę approx. 10 mm (0.39 in) of inner rod t
suziki rm12505 REAR SUSPENSION 17-15 • Inspect the bearings, spacers and oil seals for damage. • In
suzuki rm25054 15-8 FRONT FORK AND STEERING 15-8 FRONT FORK AND STEERING in) of inner rod thread •
suzuki rm25092 REAR SUSPENSION 16-19 • Inspect the bearings, spacers and dust sea
więcej podobnych podstron