7n. Product maintenance
1. The lubrication
After running belt is used for a period of time, it must be lubricated with special methylsibcon oil.
Advice:
Use less than 3 hours per week Lubricate once every 5 months Use 47 hours per week Lubricate once every 2 months
Use morę than 7 hours per week Lubricate once a month
Do not over lubricate, lubricant is not morę is better. Remember: proper lubrication improves treadmill use a big factor in longeyity.
2. Lubrication method
As for the way to check if you need morę lubricant, just grab the running belt and touch your hands as much as possible.Feel to run the center that takes the back of belt, if your hand lives to have silicone (have a little damp feeling), say to need not namely use lubricant. If the runner is dry and doesnt stick to silicone,
You need to add lubricant.
A. steps to apply lubricant to the runner:
Pour the silicone oil into the filling hole on the motor cover.
Use a speed of lkm/h to run the treadmill evenly apply silicone and tap the running belt from left to right, big
It takes about a few minutes for the silicone to be fully absorbed by the running belt.
3. Adjust the belt tightness
Ali treadmills are adjusted before deliyery and after installation, but may return after a period of use.There is relaxation. For example: the user stops and skids while running. When this occurs, press go clockwise direction to half a circle, left and right synchronous adjustment run with adjustment bolts. If you run too fast, your feet are running belt, running belt and drum turn skid phenomenon, but too tight is not good, easy to increase the load of the motor, damage motor, running belt and roller, etc
4. Off-track adjustment
Ali treadmills are adjusted before they go out of the factory and after they are installed, but they may still work after a period of use will appear to run off the phenomenon, the causes of the phenomenon are as follows
(1) the host is not placed smoothly
(2) The user shall not run outside the center when exercising
(3) the user foot force is not uniform caused by human deviation phenomenon, no-load rotation can return to normal for several minutes,for the deviation phenomenon that cannot be automatically recovered, the 6mm hexagon wrench with a cjuarter circle shall be applied unit stepwise regulation when the festival left If the stop-band right then product section side into the fuli hour hand word section
according to the right edge into the clockwise side of the national section running belt running deviation does not belong to the warranty scope, mainly by the user in accordance with the manuał self-maintenance, running deviation will be serious damage to the belt, must be found in time, timely correction.
(19) do not attacli pins, garbage or moisture to the power pług.May cause electric shock or short circuit, fire.Do not use with wet hands!
(20) do not puli out or insert the power pług with wet hands.
—It can lead to electrocution and injury.
—Puli out the power pług!
(21) when not in use, remove the power pług from the socket.
Insulation can deteriorate due to dust and moisture, which can lead to leakage fires.
Grounding instructions! Danger! warning
(22) the product must be grounded. If the machinę fails, grounding will provide the least resistance to the current To reduce the risk of electric shock.
(23) the product is ecpiipped with wires with grounding conductors and grounding plugs for the eąuipment respectively. The pług must be inserted
Properly installed and grounded, suitahle sockets have been installed in fuli compliance with local laws and regulations. Danger!
(24) improper connection of grounding conductor of equipment will lead to electric shock hazard. If you connect to the product
If the ground is in doubt, please entrust a professional electrician for inspection. Even the product comes with a pług with The socket does not fit and cannot be modified. Please entrust a professional electrician to install suitahle socket.
(25) the product has an earthing pług. Make surę the product is connected to a socket with the same shape.
This product cannot use adaptor socket.
(26) after use, the silicone oil must be stored out of reach of children, so as to avoid serious accidental ingestion.
l.Technical parameters
Color |
White/black/pink/gold |
Working voltage |
AC220V~50 Hz |
The largest load |
130 kg |
Overall dimensions |
Fold: 1200*560*180 mm |
Expand :1200 * 560 * 1120mm | |
Effective running area |
1000 * 380 mm |
Peak of motor power |
3.5 HP |
Continuous output |
0.75HP |
Speed |
1-10 km/h |
Function |
running |
Execution standard |
GB17498, 1 -2008,GB/ 17498-2008 |
Protection against electric shock |
I class |
Notę: the product will not be time to upgrade, customers to receive the kind prevail, sales company to explain tliis aU.
2. Pac king list
The serial number |
Brief |
Accessories |
Specifications |
Numbers |
1 |
silicone oil |
30ml |
1 | |
2 |
5#Socket wrench |
5# |
1 | |
3 |
6#Socket wrench |
6# |
1 | |
4 |
14wrench |
14 |
1 | |
5 |
Cross screwdriver |
/ |
1 | |
6 |
Half round head screw |
M8*15 |
4 | |
7 |
The abrupt stop switch |
/ |
1 | |
8 |
The instructions |
/ |
1 | |
9 |
Certificate of approval |
/ |
1 | |
10 |
Warranty card |
/ |
1 |