SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.

aua603gbbt.doc

MAKE

AUDI

MOD.

A6*

YEAR

03

→

→

PETROL
DIESEL

* Models with original equipment keyless entry system.

ALARM/SIREN
POSITION

Position the compact alarms and the sirens in the engine compartment, driver’s side.

CENTRAL UNIT POSITION

Position the modular systems and the modules on the left of the steering column, driver’s
side.

POWER SUPPLY

+30: connect with a ring terminal to one of the general power supply terminal in the fuse box.
- 31: connect with a ring terminal directly to the car body.

IGNITION WIRE

+15/54: connect to the 1,5 mm

2

BLUE/BLACK, wire at the position nr.4, of the orange

connector nr.15 located on the connectors holder plate behind the left bulkhead, driver’s side.

DIRECTION INDICATORS

Connect to the BLACK/WHITE wires at the position nr.9 and BLACK/GREEN wires at the
position nr.10, in the 10 way light brown connector, located behind the left sill cover, driver’s
side.

ELECTRIC WINDOWS

Comfort locking
Negative control signal
The locking of the windows is obtained timing the GREEN/BLUE doors closure wire of the
vehicle.

ACTIVAT./DEACTIVATION

Connections antitheft/vehicle

CONTROLS

Art. 3800
YELLOW/BLACK
GREY/BLACK
VIOLET
ORANGE
VIOLET/WHITE
ORANGE/WHITE

Vehicle
GREEN/VIOLET
GREEN/GREY
GREEN/WHITE
Ground
Ground
Ground

Position
Pos. nr. 10, 16 way black connector nr.2
Pos. nr. 7, 16 way black connector nr.2
Pos. nr. 12 , 20 way red connector nr. 4
Car body
Car body
Car body

The 16 way black and 20 way red connectors are located in the central of the central locking
unit placed under the moquette of the footrest of the driver’s side seat.

IMMOBILISATION POINT

Fuel pump
Cut the 1,5 mm

2

GREEN/YELLOW wire, at the position nr.32, of the 6 way light blue

connector, near the connector mentioned above.

STARTER

Relay pump supply
Cut the 1,5 mm

2

GREEN/YELLOW wire located in the wiring harness coming out of the fuse

marked nr. 34 in the fuse box.

BONNET SWITCH

Install an additional switch near the left lateral headlamp.

DOORS SWITCH

Connect to the GREEN/YELLOW wires at the position nr.1, RED/GREY at the position nr.10,
BLACK/RED at the position nr.12 and BLACK/VIOLET at the position nr.14 located in the 16
way light brown connector coming out of the modular system under the moquette on front of
the driver’s seat.

BOOT SWITCH

Positive polarity control signal
Connect to the 1 mm

2

RED/GREEN wire at the position nr.9 located in the 12 way black

connector coming out of the modular system under the moquette on front of the driver’s seat.

X