Samsung SGH-E370 IMEI write procedure

Pre-requisite:

• IMEI write program unzipped onto local PC

• Required IMEI write INI file/s from AnySVC website

• Correct jig box and cable options, connections as below:

The folder structures on your local PC for IMEI write needs to be in specific format:

NOTE: the Sub folders for each product and the sub folder “Model” are all case sensitive and
should be created in the format shown above; i.e. SGH-E370 and not sghe370 or e370.
The “BACKUP” folder is automatically created when the IMEI write program is started. You do
not need to create this folder.

1. When using the on-line IMEI write program it is advisable to have the AnySVC open

and logged into using your username and password for the site.

2. Run the Swift IMEI write program as unzipped into the folder above. The resolution of

the program is set such that not the entire programming screen is visible. Maximise
the window so that a scroll appears at the left hand side of the screen.

GH80-03306A
Jig Box

USB to Serial
Adaptor and cable
Plugged into SDS D/L
of jig box

Power supply
cable

GH39-00337A
Data cable

4.2v
PSU

NOTE: GH80-03306A
POWER ON switch
should be off to begin

PC must have internet
connection access.
Minimum connection
speed of 256kbps is
recommended

Parent folder that contains
the IMEI write program
and all DLL’s

Sub folder that contains
further sub folders titled
as the MODEL of each
phone

MODEL Sub folders that
contains unzipped INI files
for each product

3. Click on the “Set Writing Settings” button

4. From the model pull down menu select the model SGH-E370. These models will only

appear if the folder structure on your local drive is as described above, and the INI
files are extracted into each folder.

5. Next select the variant market for the product in the buyer pull down menu

6. Click on the “Set PortNum” button, and select the COM port number that the jig box is

connected to. Click “APPLY”.

7. Click on “OK” on the “Select Write Settings” window
8. Scroll down to the bottom of the main IMEI write window
9. Click on the “Go All” button.

10. Enter your IMEI write username and password. Click on “Confirm”.

11. Enter the IMEI of the handset to be restored. You will need to enter the 15 digit

(check digit) of the IMEI number. Click on “OK”.

12. When the write dialogue box gets to the “Please Jig Power On – within 30 sec!-

Thread1”, switch on the jig box to power on the handset.

13. The write process will begin. This normally takes approx 2 minutes depending on

internet connection speeds. When the write is complete and all is successful the write
program screen will look like this: