How To Make Wine At Home
Visit Us On The Web
WINE TIPS
http://www.wineselecting.com/
Wine Selecting - www.WineSelecting.com
How To Make Wine At Home
Making wine at home is not difficult, and it is a very rewarding hobby. In this article, we will go
through the equipment needed and all the steps you take to make wine from fruit – grapes, apples,
plums, pears, peaches, or whatever fruit you have.
You can also make wine at home from a kit, usually using grape concentrate, but the results are very
variable, and it is much more satisfying to make wine from fresh fruit.
You probably thought of home wine making because you have your own fruit, or have been given
some, or because fruit is in season in your area and you can get it very cheaply. Making wine is a
great way of using fruit when you cannot possibly eat it all, or make all of it into jam, or freeze it all.
I have made wine successfully from many kinds of fruit, including grapes, apples, apricots, plums
(many varieties), quinces, pears and peaches. Make sure you discard all rotten or suspect fruit right at
the start.
Assuming you have your fruit ready, here are the equipment and supplies you need.
<li> A large food grade plastic tub or stainless steel pot to squeeze or press juice into. Needs to have a
lid.</li>
<li> An electric juicer (not essential if you can squeeze or press the fruit by hand).</li>
<li> A glass fermentation vessel like a jug, carboy or demijohn (also called a 'jimmyjohn') with an
airlock. These are available at brewing shops. It is usually better to use several smaller vessels (of one
gallon capacity) than one large one.</li>
<li> A plastic tube for siphoning.</li>
<li> Yeast (available in packets at brewing shops and some supermarkets).</li>
<li>Sterilizing solution or tablets. (Not essential - you can clean equipment with boiling water.)
With this all collected, follow these steps to make your wine.
People starting out with home fruit wine making often wonder how much fruit they actually need.
Here is a tip I have found works – you need enough juice to fill the glass fermentation vessel you are
using – your carboy or demijohn. Some recipes advocate watering your fruit juice to make up the
quantity you need, but never do this. Use pure juice and your wine will be full-flavored and satisfying
to drink.
You will either press the fruit, squeeze it by hand or use an electric juicer. If squeezing by hand (soft
plums for example) you will need a large stainless steel or plastic container. If you have hard fruit like
apples or hard plums, and electric juicer is a good investment if you don’t own one already. You can
also cut up the fruit and boil it in a little water to extract the juice, but this degrades the flavor of the
final wine. If you have grapes, you can try trampling them with your feet in the traditional manner.
Wine Selecting - www.WineSelecting.com
Some fruits can be cut up and left to soak for a few days in a little water to extract the flavor and color
from the skin.
Some fruit, like apples, throw a tremendous froth after juicing and you will have to siphon the juice
out after the froth has risen to the top.
Note that mixed fruit wines are very successful. If you have only a few apricots but a lot of apples,
mix the juice to make up your gallon.
Some fruit juice, like very sweet grape juice, will not need the addition of any sugar. Most other fruit
wines will need sugar to be added. I normally add 2 pound of sugar to make up one gallon of fruit
juice. If you prefer a drier wine, you can reduce this amount. This is the reason it is better to use
several smaller glass vessels when starting with home fruit wine making – you can vary the amount of
sugar in each (record this by writing on the carboy with a felt pen); when you eventually come to
drink the wines, you will know which style between dry, medium and sweet that you prefer. More
sugar also means more food for the yeast, and so more alcoholic wine at the end of the process.
Add the sugar by warming the fruit juice slightly in a stainless steel pan, and stirring in the sugar to
dissolve it.
Sterilize your carboy or demijohn with sterilizing solution, or boiling water. Put the sugared fruit juice
into your vessel. Dissolve the powdered yeast in a little warm water and sugar in a cup, and leave it
for a few minutes to activate. Then add the yeast to the fruit juice. Put your air lock on the vessel.
Fermentation of the fruit juice should begin soon, and you will see bubbles in the air lock. This
means the yeast is converting the sugar to alcohol.
Put your fermentation vessel in a warm place if possible. Ideally you should leave the wine
fermenting for nine months to a year. If you drink it after only a month or two it will taste rough and
poor; leaving it for about a year will let it mellow out – this really makes a difference. As fermentation
goes on, you will notice a white layer appear at the bottom of the fermentation vessel. This is formed
by dead yeast cells. You can 'rack', or siphon the wine into a new vessel, which stops the wine
becoming tainted with a yeasty aftertaste. You should do this once a month.
If the wine has not clarified, and you want it to be fully clear before bottling, leave the vessel in a very
cold place for a week or so, and the clarity should improve.
When the fermentation has stopped (no bubbles coming through the air lock) you can bottle the wine
and cork the bottle. Remember to sterilize the bottles and corks before you use them. If you will be
making a lot of wine, remember to label all the bottles with details of the fruit, the yeast variety used
and date of bottling. If you make a superb batch, you can then try to replicate it in following years.
Few people can resist drinking a bottle at this stage. But most fruit wines are at their best up to two
years after bottling, so you can put a few bottles aside until you have some friends round, or have
Wine Selecting - www.WineSelecting.com
something to celebrate. There’s nothing quite like drinking your own wine, made the way you like it!
Wine Selecting - www.WineSelecting.com