Canon is a registered trademark of Canon Inc. Canon Inc. Y.Watanabe
® © ©
Leaning Tower of Pisa, Italy: Assembly Instructions
Before starting assembly:Writing the number of each section on its
back side before cutting out the sections is highly recommended. Indicates where sections should
be glued together.
(* This way, you can be sure which section is which even after cutting out
the sections.)
http://www.canon.com/c-park/en/
Reverse side of part 4
Glue the upper glue tabs of part 3
to the inside areas with circles on
the printed side of part 4.
3
View of completed model
*This model was designed for Papercraft and may differ from the original in some respects. Printed side of part 4
Assembly Instructions:Three US letter sheets(No.1 to No.3)
*Build the model by carefully reading the Assembly Instructions, in the parts sheet page order.
Carefully glue the lower glue tabs
*Hint: Trace along the folds with a ruler
of part 3 to the glue areas of part 1,
and an exhausted pen (no ink) to get a sharper, easier fold.
one at a time.
2
Assembly Instructions
Glue
Mountain fold(dotted line)
The glue spot(colored dot)
Make a mountain fold.
shows where to apply the glue.
Valley fold(dashed and dotted line)
Glue spot(Red dot)
Make a valley fold.
Glue parts with the same shape together.
Scissors line(solid line)
Glue spot(Green dot)
Cut along the line.
Glue within the same part.
Cut in line(solid line)
Glue spot(Blue dot)
Cut along the line.
1
Glue to the rear of the other part.
Scissors, set square, glue(We recommend stick glue), pencil, used
Tools and materials
ballpoint pen, toothpicks, tweezers, (useful for handling small parts)
Before gluing, crease the paper along mountain fold and valley
Assembly tip
fold lines and make sure rounded sections are nice and stiff.
Use parts 1 - 4 to build six identical components.
Glue, scissors and other tools may be dangerous to young children
Caution
so be sure to keep them out of the reach of young children.
1
Canon is a registered trademark of Canon Inc. Canon Inc. Y.Watanabe
® © ©
Leaning Tower of Pisa, Italy: Assembly Instructions
89
Glue parts 8 + 9 to the glue tabs
on the outside of parts 6 + 7.
5
Glue part 5 to the glue
Make a cut along the red line from
tabs inside parts 6 + 7.
15
the edge and then cut out the center circle.
Top of part 5
6
Side of parts 6 + 7
Glue part 15 in place after
Glue part 5 and parts 6 + 7 together
assembling the stand.
so that the narrower side of parts 6 + 7
7
faces in the same direction as the area
of part 5 on which steps are printed.
11
13
Glue part 11 to part 10 along
the circle on the inside of part 11.
10
Glue part 10 to parts 5 - 9 along the circle on
the inside of part 5.
When doing so, match the entrance printed on
part 10 to the steps printed on part 5.
5+6+7+8+9
12
14
2
Canon is a registered trademark of Canon Inc. Canon Inc. Y.Watanabe
® © ©
Leaning Tower of Pisa, Italy: Assembly Instructions
23 24
Glue part 16-24
to the top surface.
22
21
Glue parts 1 - 4 together so
that their columns are aligned.
20
Refer to this illustration when
inserting the tower into the stand.
19
18
17
16
Finished!
3