trim

trim



Dust shielding trim


Trim on front and back srewed the outside edges of plywood.

Trim screwed to side edges of middle slider, and bottom edge front and back.

glued to bottom edge before assembly.


Most of the trim was added after building up the sanwich. As such, it was added in a way that did not reguir etaking the slider sandwich apart again.

Trim between middle and upper layer of plywood is screwed to middle layer. I installed it after putting the sandwich together, and screwed it down on just the ends, as these I could get to by moving the slider forwards and back. This avoided havinq to take it all apart again to get teh trim on.

This piece of trim beveled 45 degrees and attached to the base.

of table, the dust away from below the table.


Wyszukiwarka

Podobne podstrony:
Measurements and Patterns pattern. For the patterns on the following pages, only half of the front&n
Fłxation seams The upper edge of the sąuare and the two upward diagonals - on the front and back bod
img049 mmmm Datę__Name.Front and Back Hip Roli    2. Starting Posftion: Sit correctly
00394 ?4bf53b90d85a9db56d6772e2aee78a 398 Obenchain Table 4. Yields for Processes with Mean on Targ
91 3 # APF-91 p. 02 11. Pin the bodice front and back co che slecvc aacchine A*a and 3*5 Pin and scu
70838 system 104 104EXERCISE No. 15Knee-Raising with Rubbing of Legs and Front and Back of Trunk len
Lining "Shoulder seams" Now the front and back linings can be sewn to the shirt fabric usi
img047 Spinał Mobility Front and Back Hi
box?sic Stock holding box. Build this box using fbur rectangular pieces of lumber. The front and bac
box?sic Stock holding box. Build this box using four rectangular pieces of lumber. The front and bac
INTERNATIONAL CONFEREN on Photocatalytic and Advanced Oxidation Technologies for Treatment of W
00470


więcej podobnych podstron