MR293R190�5 1

US1J9G ANTI-GRAVEL MASTIC

PrepaTation

Thoroughly raix the two coiriponents (parts A and B).

For Che products' optimum ąualities to be maintained, it ie important that che two components should be mixed in the correct proporcione^ that is co say:

-    all part A mixed with all part B;

-    half part A raixed with half part B.

Pot lLfe

The mix reraains usable for 1 hour at arabient temperaturę.

Application

For the mastic to adhere properly to bare panelling it must be preceded by one coat of chrome phosphatc primer and one coat of surfacer,

1 co 1-5 mm thick ii6ing a pressure spray gun-

Adjuscing the mastic pressure gun (Pipo 2 anti-gravel type)

The air pressure reducing valve is to be set at 3 bare.

Apply the mastic in auccessive coats

Anti-gravel pressure apray gun (Pipo 2 type)

(A) An eztruded fillet of mastic is obtained by adjusting the gun as follows:

-    unscrew *screw (1);

-    close the air delivery screw (2);

-    unscrew the product delivery screw (3) by three turns.

To spray the mastic on to body siils, rear end panels, radiator grilles, whecl arches, adjust the gun as follows:

-    unscrew screw (1);

-    unscrew screw (2) by one and a half turns;

-    unscrew screw (3) by three turns.

(b) To spray the mastic on to any type of joint, adjust the gun as follows:

-    unscrew screw (1);

- unscrew screw (2) by one turn;

- unscrew screw (3) by two and a half turns-

The gun is to be cleaned after application-

MAY BE PAINTEO TMMEDIATELY WITH TWO-POT PAINT (poLyurethanc).    ~'|