MR293R19086 1

Part no. 77 01 407 419

In the SONHATCH II rangę only roof 77 01 407 419 i3 rec-oamended

To protect the interior trim, cover the seate and instrument panel.

A) Fit the plastic cut-out template 2906 - RN 77 01 JJ0U 206 or the paper template supplied in the package on the vehicle roof 260 mm away from the upper edge of the windscreen seal.

Centre the template, ensuring that the distance between the rain channels and the edges of the template is equal; secure it using adhesive tape and eheck again that it is PERFECTLY oentred.

C) Using a 4 mm borę bit drill a hole 50 mm away from the inside of the traced linę of the cut-out section.

Enlarge the hole to 13 mm diameter.

B) Using a sharpened blade, out along the tracing lines, pressing hard enough to mark the roof, then remove the template.

NOTĘ: On v.inyl oovered roofs, reraove the vinyl located inside the opening before continuing.

D) Plaoe approximately 5 cm of adhesive tape around the traeed linę of the opening. Using a jigsaw, pass oarefully over the roof and interior trim, following the traced linę.

File the edge of the cut-out section.