230

6) Use your feeler gauge measurement and follow-ing adjusting shim chart to select correct shim thickness to give you proper output shaft endplay.

Output shaft end play adjusting shim

Thickness mm (in)	Part Number
0.3 (0.012)	31484-01X00
0.5 (0.020)	31484-01X01
0.7 (0.028)	31484-01X02
0.9 ( 0.035)	31484-01X03
1.1 (0.043)	31484-01X04
1.3 (0.051)	31484-01X05
1.5 (0.059)	31484-01X06
1.7 (0.067)	31484-01X07

25.    Artach output shaft shim to output shaft.

26.    Put gasket on transmission case.

27.    Install converter housing assembiy on transmission case.

29. Tighten converter housing securing bolts to the specified torque.

Before installing bolts marked ^j| in figurę above, ensure that boit threads are clean and that locking sealer has been applied. Also ensure that the transmission case has been cleaned with solvent.

30. Apply vaseline to lathe cut ring, then install return spring and accumulator piston on trans-

mission case.

28. Turn parking gear (rear internal gear) clockwise with screwdriver while supporting convąrter housing assembiy by hand, until output shaft splines, front carrier, and rear internal gear are engaged properly.