72

rtwt#

Removal

OIL PAN AND OIL PUMP

Inspection

1.    Drain engine oil.

2.    Remove oil pan.

(1) Drive seal cutter (special tool) into space between cylinder błock and oil pan.

Refer to LC section.

__ I nstailation

1. Install oil pump assembly.

•    Do not drive seal cutter into oil pump or rear oil seal retainer portion, or aluminum mating face will be damaged.

•    Do not drive screwdriver, or oil pan flange will be deformed.

H _:    16 - 22 N-m

(1.6 - 2.2 kg-m, 12 - 16 ft-lb)

2.    Before installing oil pan, remove all traces of liquid gasket from mating surface using a scraper.

• Also remove traces of liquid gasket from mating surface of cylinder błock. ■

3.    Apply sealant to oil pan.

(2) Slide seal cutter by tapping its side with a hammer and remove oil pan.

Liquid

gasket

Oil pan

♦ n = N-m (kg-m, ft-lb) Inner side    SEM427B

SEM884A

3. Remove oil pump assembly with oil strainer.

Apply a continuous bead of liquid gasket to mating surface of oil pan.

Be surę liquid gasket is 3.5 to 4.5 mm (0.138 to 0.177 in) wide.

Attaching should be done within 5 minutes after coating.

Wait at least 30 minutes before refilling engine oil/coolant or striking engine.

Tubę presser

[O) 5 - 7 <0.5 -0.7, 3.6 -5.1)

— Diameter of bead:

3.5 - 4.5 mm (0.138 - 0.177 in)