www.scrollsawinspirations.com Scrollergirl@aol.com Copyrighted c 2004 by Diana Thompson "Smiley Face Bank" Coin slot Read all directions before cutting patterns. Back and front of bank. See directions at left. Note: Coin slot is cut only on one side, which will be the back side of the bank. Back and front of bank Plug Cut 2 of 1/4" stock opening #5R blade Directions Apply the pattern to one piece of 1/4" stock. Drill a blade entry hole in the coin slot and plug openning and cut them out. Using pressure sensitive tape to hold the pieces together stack this piece to another piece of 1/4" stock. Cut around the outside line only. Do not remove pattern. Bank assembly. Glue the back and front Bank sides pieces to the bank sides. Cut 1 of 1 1/4" stock. Cut around the inside line, #5 blade cutting through all three thicknesses. Directions Finish as desired. Apply pattern to the stock. Cut out the inside line by drilling a small blade entry hole and threading the blade though it. Cut out around outside line and remove pattern.