opis strona 5

IMPORTANT:

Solder a wire wilh a section ol al least 1.5mm in parallel to all tinned print-paths, because they have cuirents up to 15A to transmitl

Insert the IC into their socket:

(all ot them with the stud towards L11

•IC1.type4060

•IC2,type4001

-IC3,type4013

CHECK THE ENTIRE CIRCUIT ONCE AGAIN CAREFULLYI

Execute the bores in the rear-panel ot the housing and the heatsink as shown on tig-1.

WHEN MOUNTING THE FET TRANSISTORS, BE SURĘ THE EOGES OF THE BORES ARE COMPLETELY FREE OF BURRS!

Fix the heatsink (provided with a heat-conductive pastę) by means ot (our bolts at its oorners onto the rear-panel ot the housing. Place it in such a position that the FET transistors T5 to T8, after havlng been mounted, are fitting correctly to the print, do now install the print onto the base piąte at approx. 6 mm from the rear-panel.(see fig.2)