MR293R19081 1
TIGHTEHING THE BARS
The bars muat be aeoured uniformly and equally on both sides using the handle aupplied.
The bara are supplied pre-stressed. Tighten the bar until it is horizontal.
NOTĘ: The tubę muat be fitted at least
45 mm insi de the 1'oot and vi3ible through the slot provided for thia purpose. Under no elreuwstances tnust it be tightened completely on one side only.
safkty
The bars muąt be retightened after 200 and 750 milea travel.
Take acoount of the vehiole's different road-holding behaviour (side winds, eurnering and braking) when the bars are laden.
Windsurf boards and long loada: do not driye above 50 mph (80 km/h).
THE MANUFACTURER WILL NOT BE HELD RESPONSIBLE IF THESE TNSTRUCTIONS
ARE DI3REGARDED.
Wyszukiwarka
Podobne podstrony:
Basic TechniąuesKnit Increase Without Twisting 2 stitches from front to back. and... On both sides o
MR293R19072 1 The opftratiojis doscribed below sr« to be carri M out on both the right and left ban
MR293R19000 1 The door pillar apper stiffener muSt be rcmoved before this operation can be car
56380 MR293R19051 1 (1) Hall joint ref. 77 00 753 309 (2) Nut ref. 77 01 422 012
Section DCompletionReturn of permit On completion of work, the issued copies of the permit should be
Anex nr 1 to WSSM Regulations: Hereby I order the paragraph concerning the ECTS to be added to WSSM
C..A. Mascardi (Orał discussion) Few comments can be added to the contributions by Martinetti and Di
Suzuki RM2502 FRONT AND REAR WHEELS 13-7REAR SPROCKET REPLACEMENT ♦ Tighten the nuts to the specifi
MR293R19055 1 Adjustinq the Front Latchns Adjusting the Aide Eccentrics Łiii^ Adjusting the Latch R
MR293R19067 1 Remove: - the hood striker plates, - the seal, Ap
MR293R19095 1 Fit the tikirt in place on the front and rear elips. Mark and tram t.hr location of t
więcej podobnych podstron