20536 Suzuki RM250�

9-12 FUEL SYSTEM

INSPECTION

•    Inspect the following parts for damage: Jet needle

Throttle valve Float

•    Inspect the following jets for clogging: Main jet

Slow jet Starter jet Power jet

•    Inspect the needle valve for wear.

♦ Measure the float height with a vernier caliper. To measure the float height, tilt the carburetor until the float tip just con-tacts the float valve.

E5S5S Standard float height: 6.5 ±1.0 mm (0.26 ± 0.04 in)

REASSEMBLY AND REMOUNTING

Reassemble the carburetor in the reverse order oKremgyak

attention to the following pints:    \ k \ \ \\^) ^v

\ X X \ >

NOTĘ:    / /......\ ’-•>, >

Fit the projection of throttle vśivę..coliar ip the groove of cable hoićer.    ^ J

NOTĘ:

Set the throttle position sensor guide roHer as shown when installing the throttle valve into the carburetor body.