226

226




lO. Install shell & sun gear assembly, thrust needle bearing and bearing race.

SAT275


Available retainer plate

Thickness mm (in)

Part Number

3.6 (0.142)

31667-01X00

3.8 (0.150)

31667-01X01

4.0 (0.157)

31667-01X02

4.2 (0.165)

31667-01X03

4.4 (0.173)

31667-01X04


11. Install Iow and reverse brake driven & drive plates and retaining plate, then secure with snap ring.

SAT274

12. After Iow and reverse brake has been complete-ly assembled, measure clearance between snap ring and retainer plate. If measurement exceeds specifications, it can be adjusted by replacing retainer plate with one of a different thickness.

Low and reverse brake clearance:

Standard

1.90 - 2.20 mm (0.0748 - 0.0866 in) Allowable limit

3.8 mm (0.150 in)

13.    Install bearing race on connecting shell.

14.    Install one-way clutch assembly to rear carrier.

SAT390

15. Install thrust washer on rear carrier.

AT -47


Wyszukiwarka

Podobne podstrony:
r > H fic 1 ■f* / Thrust needle bearing Bearing race
14035 Suzuki RM125? 6-10 CYLINDER, PISTON AND EXH AUST VALVE •    Install the exhaust
A6E5714A05026 BEARING 3-4 CLUTCH HUB SNAP RING REAR SUN GEAR PLATĘ A6E5714A050
gear assemblies Gear assemblies Piece of 3/4" dowel, 2 cm long 3/8 threaded rod, 16 threads per
Table5 On the following table: Prepare the ooom 509 of the jib assembling the rings 540 and the coll
suzuki rm25007 COOLING SYSTEM 10-5IMPELLER AND GEAR SHAFT • Inspect the impeller and gear shaft for
32 (236) Y E L L O W “But I mean to say that it is not easy to find a summer sun effect which is as&
22 ■ Lo Devoif. jeudi 28 mars 1985Consommation et Corporations CanadaConsumer and Corporate Affairs
89 TransAlp Manual Clutch Gearshift Linkage 7 4 CLUTCH/GEARSHIFT LINKAGE Check the needle bearings f
2277-8 Kelric returns home (Ascendant Sun); Dehya coalesces (Spherical Harmonie); Kamoj and Havyrl m
L’estate (Sum 0
73666 Suzuki RM2507 COOLING SYSTEM 10-5IMPELLER AND GEAR SHAFT * Inspect the impeller and gear shaf
step After assembling the buttsiock, assemble the młd part and glue as shown. Notę that I left it h
VOLVOD0 1 6 (94 konie) InstallationInstallationNOTĘ: From 1988 the positions of guide pulley and ten

więcej podobnych podstron