MR293R190_727









































REAR AXLE
Bearings on tubular type rear axles
Push down the assembly (D) and (C) until sleeve
(C) is flush with edge (3) of the tube.
Fit :
-
the small bearing track in the sleeve (C),
-
the sleeve (C) over the tube with sleeve (D)
acting as a guide.
Push down on the press until sleeve (C) is flush
with edge (3) of the tube.
Remove sleeves (C) and (D).
IMPORTANT
When pushing in the bearings, if the load is being
taken on the axle mounting bearing assemblies, it
is essential to ensure that the suspension bars are
correctly located in their anchor points (there is a
risk of them coming out).
Recentralise them if necessary.
Assemble the two half suspension arm assemblies.
NOTE : It is not necessary to grease the needle
races.  They are supplied ready greased.
Then reconnect and refit the rear axle to the
vehicle (see corresponding section).
33
90867-2R
90867-4R
90867-3R
Fit :
-
the large bearing track into the sleeve (D),
-
the assembly of sleeve (D) and (C) over the
tube.
90867-5R
33-36