5441336738

LABORATORIUM JARINGAN KOMPUTER

JURUSAN TEKNIK ELEKTRO - INFORMATIKA FAKULTAS TEKNIKUNIYERSITAS ISLAM MALANG 2009-2010

10.0.0.0. This combination matches all addresses that begin with 10 in the first octet. So, this one network command matches all three of Albuquerque's interfaces, puts them in Area 0, and causes Albuquerque to try to discover neighbors on those interfaces. It also causes Albuquerque to advertise the three connected subnets.

The next example shows an alternative configuration for Albuquerque that also enables

OSPF on every interface. In this case, the IP address for each interface is matched with a

different network command. The wildcard mask of 0.0.0.0 means that all 32 bits must be

compared, and they must match—so the network commands include the specific IP address

of each interface, respectively. Many people prefer this style of configuration in production

networks, because it removes any ambiguity about the interfaces on which OSPF is running.

interface ethernet 0/0

ip address 10.1.1.1 255.255.255.0

interface serial 0/0

ip address 10.1.4.1 255.255.255.0

interface serial 0/1

ip address 10.1.6.1 255.255.255.0

router ospf 1

network    10.1.1.1    0.0.0.0    area    0

network    10.1.4.1    0.0.0.0    area    0

network    10.1.6.1    0.0.0.0    area    0

XI.    BEGINNING ASSESMENT (TUGAS PENDAHULUAN )

1.    Describe Dynamie Routing Using OSPF !

2.    Give the example of command in Dynamie Routing Using OSPF and explain !

XII.    PRACTICUM (PRAKTIKUM)

A.    REQUIRED EQUIPMENT (ALAT & BAHAN)

3.    Two established LANs

4.    Multiple routers depend on router specification, chek your router list in Boson Network Designer

5.    Cables (not used in virtual lab)

B.    PROCEDURĘ LIKE IN LAB 3 (LANGKAH-LANGKAH)

C.    QUESTION ( PERT AN YA AN)

6.    Delete previous routing protocol configuration, use sh ip ro to see your active routes installed in router.

7.    Use design of sample lab C and try to configure all router using OSPF routing protocol

8.    With design of FT Unijoyo Network, add OSPF routing protocol at all Lab router to connect one to each other. Don’t give OSPF to FT router. Use ping, and traccrt to check your configuration.

9.    Instructor’s assignments.