{\rtf1\ansi\deff0{\fonttbl{\f0\fnil MS Sans Serif;}}
{\colortbl ;\red255\green0\blue0;\red0\green0\blue0;}
\viewkind4\uc1\pard\qc\cf1\lang2057\b\f0\fs24 G75 Rectangular pocket milling, clockwise
\par \pard
\par \cf2\b0\fs20 G75 P01 -1 P02 -10 P03 -4 P04 80 P05 X+40 P06 Y+25 P07 150
\par
\par G75\tab Rectangular pocket milling, clockwise
\par P01\tab Set-up clearance
\par P02\tab Milling depth (depth of pocket)
\par P03\tab Pecking depth (depth of cut)
\par P04\tab Feed rate for vertical feed
\par P05\tab 1st axis and side length of pocket
\par P06\tab 2nd axis and side length of pocket
\par P07 \tab Feed rate for milling
\par
\par When using G75 or G76 to produce rectangular pockets the cutter radius must be the same as the corner radius in the pocket (although these canned cycles account for the cutter radius when machining the sides of the pocket they do not generate the corner radius).
\par
\par Parameter P01 must have the same value as the distance in Z from the tool to the work piece surface when the tool is in starting position i.e. -1.
\par
\par Cycle parameters P01/P02/P03 must have the same sign - usually - (minus).
\par
\par Cycle parameters P05 and P06 must have a positive sign.\cf1\b\fs24
\par }