POCKET3 Rectangular Cycle


{\rtf1\ansi\ansicpg1252\deff0\deflang2057{\fonttbl{\f0\fnil\fcharset0 MS Sans Serif;}{\f1\fswiss\fcharset0 Helvetica;}{\f2\fswiss\fcharset0 Helvetica-Bold;}{\f3\fnil\fcharset238 Verdana;}}
{\colortbl ;\red255\green0\blue0;}
\viewkind4\uc1\pard\qc\cf1\b\f0\fs20 POCKET3 Rectangular Cycle
\par \pard
\par
\par \cf0\b0\f1 The cycle can be used for roughing and finishing. For finishing, a face cutter is required.
\par The depth infeed will always start at the pocket center point and be performed vertically from
\par there; thus it is practical to predrill at this position.
\par
\par \b\f2\fs18 N30 POCKET3 (5, 0, 0.5, -17.5, 60, 40, 8, 60, 40, 0, 4,0.75, 0.2, 1000, 750, 0, 11, 5, , , , , )
\par
\par \fs22 Programming example: Pocket
\par \b0\f1\fs20 Use this program to machine a pocket in the XY plane which is 60 mm in length, 40 mm in width, and which has a corner radius of 8 mm and is 17.5 mm in depth. The pocket has an angle of 0 degrees to the X axis. The final machining allowance of the pocket edges is 0.75 mm, 0.2 mm at the base, the safety distance in the Z axis, which is added to the reference plane, is 0.5 mm. The center point of the pocket lies at X60 and Y40, the maximum depth infeed is 4 mm.
\par The machining direction results from the direction of rotation of the spindle in the case of synchronous milling. A milling cutter with 5 mm radius is used.
\par Merely a rough machining operation is to be carried out.
\par
\par \f3\fs16
\par \f1\fs20
\par
\par \pard\qc
\par }


Wyszukiwarka

Podobne podstrony:
POCKET4 Circular Cycle
G172 G173 Rectangular Pocket Milling
G76 Rectangular Pocket Milling CounterClockwise
G75 Rectangular Pocket Milling Clockwise
Cycle Def 4 0 Pocket Milling
G86 Grooving Cycle
Rectangle2D
CYCLE76 Rectangular Spigot Milling
G88 Chip Cutting Drill Cycle with Redraw
G94 End Taper Face Turning Cycle
User Guide PocketBooka3(EN)
Cell Cycle
G75 Outer Internal Dia Drilling Grooving Cycle
Turbo Cycle Guide81Part 2

więcej podobnych podstron