{\rtf1\ansi\ansicpg1250\deff0\deflang1045{\fonttbl{\f0\fnil MS Sans Serif;}{\f1\fswiss\fcharset0 Tahoma;}}
{\colortbl ;\red255\green0\blue0;\red0\green0\blue0;}
\viewkind4\uc1\pard\qc\cf1\lang2057\b\f0\fs24 G74 Slot milling
\par \pard
\par \cf2\b0\fs20 G74 P01 -2 P02 -20 P03 -10 P04 80 P05 X+50 P06 Y+10 P07 150
\par
\par G74 \tab Slot milling
\par P01\tab Set-up clearance
\par P02\tab Milling depth
\par P03\tab Pecking depth
\par P04\tab Feed rate for vertical feed
\par P05\tab Longitudinal axis and length of slot
\par P06\tab Transverse axis and width of slot
\par P07 \tab Feed rate
\par
\par Notes:
\par The start position in X & Y for G74 must be the 'rad centre' at one end of the slot. The finished slot will have a small flat section at each end as a true radius is not produced!
\par
\par Parameter P01 must have the same value as the distance in Z from the tool to the work piece surface when the tool is in starting position i.e. -1.
\par
\par Cycle parameters P01/P02/P03 must have the same sign - usually - (minus).\cf1\b\fs24
\par \pard\qc\f1
\par \pard
\par \cf0\lang1045\b0\f0\fs16
\par }