Rozrzad 6
ENGINE-’L’SERIES
21.
22.
17. Insert locking pin LRT-12-141 through hole in FIP drive gear and into hole in adapter piąte. Locking pin must be a sliding fit. If pin is a tight fit. proceed as follows.
18. Loosen 4 bolts securing FIP timing belt drive gear to hub.
19. Loosen timing belt tensioner pulley Allen bolt.
20. Using a torque wrench fitted to tensioner pulley backplate. apply a clockwise (viewed from rear of engine) torque loading of 6 Nm to drive belt. Maintain loading and tighten tensioner pulley Allen bolt to 44 Nm.
Fit torque wrench to square hole in FIP timing belt drive gear as shown and apply an anti-clockwise (viewed from rear of engine) torque loading of 25 Nm . Maintain loading and tighten 4 bolts securing gear to 25 Nm. Remove locking pin LRT-12-141 and timing pin LRT-12-058.
CAUTION: Do not exceed the specified l\ torque figurę.
A
REPAIRS
Wyszukiwarka
Podobne podstrony:
Rozrzad 7 ENGINE-’L’ SERIES 25. Insert locking pin LRT-12-141 through hole in FIP drive gear and int
Rozrzad 3 ENGINE-’L’ SERIES 17. Remove and discard 3 Torx screws securing dam
Rozrzad 1 ENGINE -’L’SER!ES RefitBELT - CAMSHAFT DRIVE 1. Position oil cooler. 2.
Rozrzad 2 ENGINE-’L’SERIES Ali models 5. Fit lifting bracket LRT-12-138 to lifting
Rozrzad 4 ENGINE-’L’SERIES 24. Remove timing belt tensioner access pług from
Rozrzad 5 ENGINE-’L’ SERIES 10. Fit belt tensioner access pług to back cover. 11.
Rozrzad 8 ENGINE-’L’SERIES Models fitted with air conditioning 39. Fit compressor
220 Recenzje, omówienia i sprawozdania Ap 21,1-4.22-17. Studium egzegetyczno-teologiczne z uwzględni
CO(UIW> URN MUSI* TIM7 OM MONIU » f • « 10 II U IJ 14 Ił l« 17 10 Ił 20 21 22 I 2 3 4 < 4 7 Ił
DSCN0079 C002INA 021 Eli MIESIĄC TIME OAY Morim 6 7 8 9 10 II 12
SSM10120 (2) Udatność ukorzeniania 1 3 4 5 6 7 8 10 11 12 1
więcej podobnych podstron