suzuki rm25058

suzuki rm25058



15-12 FRONT FORK AND STEERING

DISASSEMBLY

•    Set rebound and compression damper settings to the minimum settings (softest) before disassembling. Record the set-ting before turning the adjuster.

•    Thoroughly clean the fork before disassembly.

_CAUTION_

Scratches or other damage on the inner tubę or on the oil seal lip will cause oil leak.

Avoid scratching or damaging the inner tubę or the oil seal. Use a mild detergent or car wash soap and sponge out dirt with plenty of water.




•    Clamp the outer tubę with a vise. Protect the outer tubę with a rag when using a vise.

•    Loosen and remove the fork cap bolt (sub-tank) from the outer tubę and slowly slide down the outer tubę.

ItoSlI 09941-53630: Front fork top cap wrench

• Place a drain pan under the front fork.and d NOTĘ:

Face the oil hole ® on the sl, do

• Raise the outer tubę and temporarily install the fork cap bolt © (sub-tank) to the outer tubę.



Wyszukiwarka

Podobne podstrony:
41913 Suzuki RM2508 15-22 FRONT FORK AND STEERING • Clamp the axle holder with a vise. Protect the
suzuki rm25056 15-10 FRONT FORK AND STEERINGSUSPENSION BALANCE Balancing the front to rear suspensi
suzuki rm25060 15-14 FRONT FORK AND STEERING • With the outer tubę compressed by hands, remove the
suzuki rm25062 15-16 FRONT FORK AND STEERING • Remove the compression damper unit from the sub-tank
suzuki rm25064 15-18 FRONT FORK AND STEERINGSLIDE BUSHING AND GUIDE BUSHING Inspect the “teflon coa
suzuki rm25066 15-20 FRONT FORK AND STEERING •    Apply fork oil to the O-rings and
suzuki rm25068 15-22 FRONT FORK AND STEERING 15-22 FRONT FORK AND STEERING • Clamp the axle holder
suzuki rm25070 15-24 FRONT FORK AND STEERING •    Tighten the fork upper clamp bolts
suzuki rm25072 15-26 FRONT FORK AND STEERING •    Remove the steering nut with the s
Suzuki RM2502 15-16 FRONT FORK AND STEERING • Remove the compression damper unit from the sub-tank.
Suzuki RM2504 15-18 FRONT FORK AND STEERINGSLIDE BUSHING AND GUIDE BUSHING Inspect the “teflon coat
Suzuki RM2500 15-24 FRONT FORK AND STEERING •    Tighten the fork upper clamp bolts
Suzuki RM2502 15-26 FRONT FORK AND STEERING • Remove the steering nut with the special tools. IK531

więcej podobnych podstron