suzuki rm25064

suzuki rm25064



15-18 FRONT FORK AND STEERING

SLIDE BUSHING AND GUIDE BUSHING

Inspect the “teflon coating metals” (slide bushing and guide bushing) for wear or damage. If they are worn or damaged, replace them with new ones.

Inspect the metal particles on the “teflon coating metals”. If they are not clean, clean them with a nylon brush and fork oil.

REASSEMBLY

INNERTUBE

•    Apply front fork oil to the oil seal lip and the dust

•    Cover the inner tubę with a plastic film.

•    Install the following parts to the inner tubę:

New dust seal ©

Stopper ring (D New oil seal



NOTĘ:

*    Clean all fork parts before reassembling.

*    Replace the O-rings, oil seal and dust seal with the new ones.

*    Apply specified front fork oil when installing the O-rings, slide bushing, guide bushing, damper unit and other sliding parts.

Scratches on the oil seal lip can cause oil leaks.


When installing the seal, place a plastic film over the bushing attachment groove and edges of the inner tubę to avoid damage to the seal lip.


NOTĘ:

The side of the oil seal that has a mark should face the dust seal.

   Remove the plastic film and then install the seal retainer guide bushing © and slide bushing ©.

•    Clean the parts and keep them free from dust.

NOTĘ:

Inspect the bushings for burrs. If there is a burr, remove it with a knife, taking care not to peel off the teflon coating. If the bushings have a large crack or excessive play after installing them, replace them with the new ones.

   Insert the inner tubę into the outer tubę.



Wyszukiwarka

Podobne podstrony:
Suzuki RM2504 15-18 FRONT FORK AND STEERINGSLIDE BUSHING AND GUIDE BUSHING Inspect the “teflon coat
41913 Suzuki RM2508 15-22 FRONT FORK AND STEERING • Clamp the axle holder with a vise. Protect the
suzuki rm25056 15-10 FRONT FORK AND STEERINGSUSPENSION BALANCE Balancing the front to rear suspensi
suzuki rm25058 15-12 FRONT FORK AND STEERINGDISASSEMBLY •    Set rebound and compres
suzuki rm25060 15-14 FRONT FORK AND STEERING • With the outer tubę compressed by hands, remove the
suzuki rm25062 15-16 FRONT FORK AND STEERING • Remove the compression damper unit from the sub-tank
suzuki rm25066 15-20 FRONT FORK AND STEERING •    Apply fork oil to the O-rings and
suzuki rm25068 15-22 FRONT FORK AND STEERING 15-22 FRONT FORK AND STEERING • Clamp the axle holder
suzuki rm25070 15-24 FRONT FORK AND STEERING •    Tighten the fork upper clamp bolts
suzuki rm25072 15-26 FRONT FORK AND STEERING •    Remove the steering nut with the s
Suzuki RM2502 15-16 FRONT FORK AND STEERING • Remove the compression damper unit from the sub-tank.
Suzuki RM2500 15-24 FRONT FORK AND STEERING •    Tighten the fork upper clamp bolts
Suzuki RM2502 15-26 FRONT FORK AND STEERING • Remove the steering nut with the special tools. IK531

więcej podobnych podstron