307

307



BODY END AND DOOR


When removing and installing hood or back door, place a cloth or other padding on hood corners to avoid scratching vehicle body.

When removing clip or fastener, refer to CLIP & FASTENER.

Apply sealing compound where necessary when installing parts.

Front End

- -*-

•    Hood adjustment: Adjust at hinge portion.

•    Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood locks engaginy mechanism.

•    Hood opener: Do not attempt to bend cable forcibly. Doing so increases effort required to unlock hood.

•    Front grille: It is madę of plastic, so do not use excessive force and take care to keep oil away from it.

•    Bumper fascia: It is madę of plastic, so do not use excessive force and take care to keep oil away from it.

Bumper rubber adjustment ~\

n 4.3 - 5.5 (0.44 - 0.56. 3.2 - 4.1)-

Cowl top grille

iHJ 5.1 - 6.5 (0.52 • 0.66. 3.8 -4.8)

Bumper helght H (Measure within 60 cm (23.6 in)

• of vehicle center Ground ^ onnghtand

Condition: Curb weight & normal tire pressure on leveł ground

8umper fascia -

. Grease-up point ^ : N-m (kg-m. ft-lb)

* : Bumper assembly

mounting bolts & nuts


left sides.l


Bumper height H:

486 • 547 mm (19.13-21.54 in)

f Ground

/; s / / //V7-


SBF378B


SBF249D


Wyszukiwarka

Podobne podstrony:
BODY END AND DOOR-Rear Door-•    When removing door. be surę not to scratch vehicle b
BODY END AND DOOR_Rear End__ •    Back door adjustment: Adjust at hinge for proper ba
BODY END AND DOOR-Back Door Opener-• Opener cable: Do not attempt to bend cable using excessive forc
BODYCONTENTS GENERAL SERVICING.................................................... BF- 2 BODY END AN
Pertamk. 14(1). 7-13(1991)The Effects of S02 and NO,, Singly or in Combination on the Growth Perform
BRAKE HYDRAULIC LINĘ .Inspection.Removal and Installation. CAUTION: a.    When removi
SEAT • When removing or installing the seat trim, carefully handle it to keep dirt out and avoid
ENGINE COOLING SYSTEM _Water Pump_ REMOVAL AND INSTALLATION •    When removing water
SMREAR DRUM BRAKE (LT18B) ___Removal and Installation- of Adjuster When installing, measure inner di
INTERIOR AND EXTERIOR •    When removing clip or fastener, refer to CLIP & FASTEN
WINDSHIELD AND WINDOWS_Windshield_•    This portion requires sealing. When removing,
WINDSHIELD AND WINDOWS_Back Door Window (Cont d)_ REMOVAL AND INSTALLATION FOR UNBROKEN
December 2014    Follow BPIE Q E O LinkedQ Edito 2014 is coming to an end, and when l
15 1 Finał contract When negotiations are closing to the end and everything is clarified. it is the
39359 Suzuki RM125s ENGINE REMOVAL AND INSTALLATION 5-9 * Reassemble the drive Chain clip so the sli
image php ilfl=ECA01P1&s=0 7 BODY PAINT AND INTERIOR COLORS This lisi shows combmation of body paint

więcej podobnych podstron