95

95



ENGINE LUBRICATION SYSTEM

INSPECTION

1.    Visually inspect components for wear and

damage.

2.    Check oil pressure regulator valve sliding sur-face and valve spring.

If damaged, replace valve set.

3.    Using a feeler gauge, check the following clearances.

SLC454


SLC45S


Unit: mm (in)

Rotor tip clearance ©

Outer rotor to body clearance (2)

Rotor to straight edge (Side clearance with gasket) ©

Less than 0.2 (0.008) Less than 0.25 (0.0098)

Less than 0.2 (0.008)

■ !.a    a a - a.ot a- )k ,-

ii-GrA


3 .]    : jl •    .

IśO -;OT qrr.jq ,:o


i ‘    v*



Wyszukiwarka

Podobne podstrony:
ENGINE LUBRICATION SYSTEM .Oil Pump.On-vehicle Service ST25052000 -(J25695-2) ----------- .... . . .
89 TransAlp Manual Cooling System 5 4 COOLING SYSTEMINSPECTION Inspect the thermostat visually for d
ENGINE COOLING SYSTEM_Thermostat INSPECTION 1.    Check for valve seating condition a
suziki rm12535 12-6 COOLING SYSTEM • Inspect the bearing for smooth inner race movement. • Remove t
20536 Suzuki RM250? 9-12 FUEL SYSTEMINSPECTION •    Inspect the following parts for d
69818 Suzuki RM1255 12-6 COOLING SYSTEM • Inspect the bearing for smooth inner race movement. 12-6
Suzuki RM1255 12-6 COOLING SYSTEM • Inspect the bearing for smooth inner race movement. 12-6 COOLIN
Comparison ofLiguid Pr opel font Rocket Engine Feed Systems - 1 - 14 For each calculation routine, i
44763 Suzuki RM125 8 17-18 REAR SUSPENSION • Insert the spacers into the bearings and inspect them f
57 01c435c120 INSP ADJFU EL LIMĘ INSPECT10N/Y.E.I.3, HOSE SMSPECTION/ EXHAUST SYSTEM INSPECTION/FRON
suziki rm12508 17-18 REAR SUSPENSION • Insert the spacers into the bearings and inspect them for pl
suzuki rm25094 REAR SUSPENSION 16-21 • Insert the spacers into the bearings and inspect them for ex
89 TransAlp Manual?ttery Charging System 8 BATTERY/CHARGING SYSTEMUNIT INSPECTION Provided the Circ
89 TransAlp Manual Fuel System 4 FUEL SYSTEM Inspect throttle operation as described bolow: • Open
29111 Suzuki RM2507 11-8 EXHAU$TVALVE 11-8 EXHAU$TVALVE *    After assembling the ex
Изображение37 5-16 Chapter 5 Engine electrical systems 18.4 Typical starter motor mounting for 2.5L

więcej podobnych podstron