1995 > G 2.0 DOHC

Removal

1. Disconnect negative battery cable. 2. Remove the three clips attaching the trim panel to the upper shroud panel. 3. Remove the screw retaining the radiator grille to the hood stay. 4. Carefully depress the four tabs on the radiator grille and remove the grille from the vehicle. 5. Remove the radiator grille clips from the side shroud panels and attach them to the grille. 6. Disconnect the condenser fan assembly electrical connector. 7. Remove the three condenser fan bolts and remove the condenser fan assembly. Installation 1. Position the condenser fan in front of the radiator. 2. Install the three mounting bolts. Tighten bolts to 80 lb-in (9 N·m). 3. Connect the condenser fan assembly electrical connector. 4. Carefully snap the radiator grille into place in front of the radiator and condenser, then secure using the previously removed screws. 5. Connect the negative battery cable. Inspection 1. Connect an ohmmeter to the condenser fan wire harness terminals and check for continuity, if there is no continuity, replace the fan motor. 2. Connect a 12V DC source (battery) to the fan motor terminals. If the fan does not turn, replace the fan motor.

---