tmta 0

20 cm

5

6

6. Short sleeve for Fig 2

This later sleeve reaches about halfway down the upper arm, and is seen on kirtles worn for work.

Measure the required length down the back ot the arm.

Tracę the sleeve Błock. Measure the required length from BP down the back seam lines and rule a construction linę AA.

For a loose fit, simply follow the Błock outline and draw a shallow curve for the lower edge ot the ' sleeve.

For a closer fit, take in the sleeve a little on both edges, as shown.

5. Sleeve with mitten cuff for Fig 2 (Pis 2, 3)

Tracę the sleeve Błock, extending the Front linę, shown broken, by 10-12 cm.

Measure round the wearer's knuckles, across the widest part ot the hand, and plan the new sleeve end. Both edges ot the cuff are the same shape and are centred on the Front linę. Make the wrist and cuff close-fitting, and leave the seam open for 10-15 cm up the arm from the wrist, shown by balance marks. Fasten with 12 or morę buttons.

20 cm

90