tmta6

tmta6



21    sp



-


21. Finished sleeve draft

Tracę the draft (Fig 20), turn it over along the Front linę, then tracę the Wrist, the Seam linę and the lower sleeve head curve to see the fuli sleeve pattern. Check that the sleeve head forms a continuous curve. Draw a slightly curved wrist shape to eliminate the angle on the Front linę. The shaping has been exaggerated a little here. Mark both the Front linę and Basic linę on the finished Błock for reference. The Straight Grain normally falls

on the Basic linę. Mark the wrist opening 10 cm up each seam linę.

On the sleeve head, measure the distance from SP to BP. Transfer this length less 0.5 cm down the back armhole ot the bodice Błock, starting from the shoulder (SP). Label the lower point BP. This provides the basie reference point for setting in sleeves.

36


Wyszukiwarka

Podobne podstrony:
79721 tmta6 r 21. Sleeve for Fig 18 A tapered sleeve with pleats at the shoulder, drafted in two st
61893 tmta6 Platę 2. Fastening for a mitten sleeve A mitten sleeve, shown unbuttoned. It was worn m
tmta7 Platę 3. Partly buttoned mitten sleeve In wear the buttons would puli to the ends of the butt
tmta6 Surcotes Surcote is used here to describe a rangę of early outer garments worn over a main
tmta6 6. Chaperon, mid 15th century, Pis 12,19 a.    The finał development of the ho
tmta6 6. Two-stage seams These give a fiat, fully-enclosed finish for linens and lightweight wools.
Skan6 21. Auf ahnliche Weise kónnen die anderen Umkehrfunktionen zu den Hyperbelfunktionen gefunden
81324 tmta1 27    sp 27. Sleeve for Fig 24 This narrow sleeve has an extension formi
tmta7 22 SP 20 cm 22. Sleeve for larger armhole This method of adapting the sleeve Błock from Fig 2
tmta7 21b SP b. Stage 2 Adding fullness to the sleeve head and I wrist I On a fresh piece of paper

więcej podobnych podstron