30

ENGINE MAINTENANCE

Before Engine Starts (Cont'd)

1. To flush system, open drain cock at bottom of radiator. Then thoroughly flush until elear water comes out.

Loosen

Loosen ^

CS009

2.    Close drain cock.

3.    Fili radiator with coolant up to specified level. Follow instructions attached to anti-freeze Container for mixing ratio of anti-freeze to water.

Coolant capacity:

Without heater

4.3 liters (4-1/2 US qt, 3-3/4 Imp qt) With heater

4.7 liters (5 US qt, 4-1/8 Imp qt)

4. Run engine for a few minutes, and then check coolant level, and check drain cock and pług for any sign of leakage.^    /■ V 1

C HANG ING .ENGINE OIL AND REPLACING

'^>b«Cł0.j BHJ X iLu j iaVh.i

OIL FILTER

.:od ii ji*ign& dnt nenw

1.    Start engine and warm it up until water tem-^perature^indicator points toimiddle of gauge,

then turn off engineTCH"

2.    Remove oil filier cap and oil pan drain pług, and ailow oil to drain.

WARNING:

To avoid the danger of being scalded, never a tempt to change engine oil when the engine is hot

Puli out

SMA503A

•    A milky oil indicates the presence of cooling water. Isolate the cause and take corrective measure.

•    An oil with extremely Iow viscosity indicates dilution with gasoline.

3.    Using oil filter wrench, remove oil filter.

4.    After draining engine oil, wipe oil pan drain hole with a clean rag.

5.    Clean and install oil pan drain pług with washer.

6.    Wipe oil filter mounting surface with a clean rag.

7.    Smear a little engine oil on rubber seal of new oil filter.

Screw in oil filter until a slight resistance is felt, then tighten an additional 2/3 turn.