VALVE INSERTS
Check valve inserts for any evidence of pitting at
valve contact surface, and reseat or replace if exces-
sive!y worn out.
• When repairing valve inserts, check valve and valve guide for wear beforehand. If worn, replace them. Then correct valve seat.
• Cut or grind valve inserts uniformly with both hands.
If necessary, replace valve inserts as follows:
1. After removing valve insert, ream the cylinder head recess.
2. Heat cylinder head to a temperaturę of 150 to 160°C (302 to 320° F).
3. Press fit insert until it seats on the bottom, and caulk morę than 4 points.
4. Cut or grind valve inserts using suitable tool to the specified dimensions as shown in S.D.S.
Wear limit:
0.15 mm (0.0059 in)
5. After cutting, lap valve inserts with a lapping compound.
6. Check contact condition of valve inserts.
CAMSHAFT RUNOUT
*: Total indicator reading
EM302